BTK-722 BLUETOOTH ® HEADSET USERS MANUAL JW_Blue_BT42_Booklet.
INTRODUCTION STOP AND READ BEFORE YOU BEGIN TO USE YOUR JUST WIRELESS® BLUETOOTH® HEADSET, YOU MUST FULLY CHARGE AND PAIR IT WITH YOUR MOBILE PHONE. PLEASE READ THE ENCLOSED USERS MANUAL FOR EASY PAIRING INSTRUCTIONS. SHOULD YOU NEED ASSISTANCE, PLEASE CALL 888-753-6957. Thank you for purchasing the Just Wireless Bluetooth® Headset. We hope you enjoy it. This manual will get you started and help you to get familiar with the features of your headset.
F E AT U R E D I A G R A M 4 Volume Higher 3 Volu Volume Low Lower 1 Microphone JW_Blue_BT42_Booklet.indd Sec1:2-Sec1:3 Adjustable Ear Hook 6 Earphone 2 Main Button 2 Charging Port 5 7 1 LED Indicator Light /Main Button a) Blue mode indicates active/standby. • 2 Consecutive Flashes: Your Bluetooth® Headset is not connected to your mobile phone. • 1 Consecutive Flash: Your Bluetooth® Headset is connected to your mobile phone. b) Red mode indicates battery level.
G E T T I N G S TA R T E D CHARGING YOUR HEADSET Your Just Wireless® Bluetooth® Headset comes with a built in rechargeable battery, and must be fully charged before using. Use the supplied USB Cable to charge your headset by plugging it into the charging jack shown below. TURNING THE HEADSET ON AND OFF ON Mode: Press and hold down the Main Button for 3 seconds. Your headset will beep and the blue LED light will flash 5 times. Now your headset is on.
PAIRING AND CONNECTING YOUR HEADSET TO YOUR MOBILE PHONE Pairing is a process of linking the Bluetooth® Headset with your mobile phone. Before using your Bluetooth® Headset, you must successfully pair it to your mobile phone. Your mobile phone must be Bluetooth® compatible. If it is not, you will not be able to pair the headset to your mobile phone. Check the users manual of your mobile phone to see if it is Bluetooth® compatible.
Step 4 - Connecting: Most phones require an additional step to “connect” to a Bluetooth® Headset. Follow the instructions in your mobile phone users manual. Once connected, your Bluetooth® Headset LED light will flash 1 time consecutively. If either the Bluetooth® Headset unit or your mobile phone is turned off, most mobile phones will allow you to automatically connect back to your Bluetooth® Headset once your headset or mobille phone is turned back on.
H O W T O U S E T H E F E AT U R E S ANSWERING CALLS • Tap the Main Button of your headset to answer an incoming call. VOICE COMMAND DIALING • Tap the Main Button, and after the “BEEP” speak loudly and clearly your desired name. Some phones do not support this feature. • For the Bluetooth® Headset, depending on your phone’s capability, when answering the call from your phone’s keypad you may need to tap the main button 2 times to transfer from the phone to the Bluetooth® Headset.
PLACING A CALL ON HOLD • Tap the volume lower button and volume higher button of your Bluetooth® Headset at the same time. To resume your conversation tap the volume lower & volume higher button again. Your mobile phone must support this feature. REJECTING A CALL • Press and hold down the main button of your Bluetooth® headset until a short tone is heard in approximately 4 seconds and then release the main button.
TROUBLESHOOTING QUESTION: I hear static noises. RESPONSE: 1. Your headset may be too far away from your mobile phone. Your headset should be within 30 feet of your mobile phone. 2. Your battery may need to be charged. QUESTION: I cannot hear anything inside my headset. RESPONSE: 1. Increase the volume level on the headset. 2. Confirm that the headset is paired to your mobile phone. 3. Confirm that the mobile phone is connected to the headset. If it does not connect, follow the pairing procedures once again.
STORING YOUR BLUETOOTH HEADSET Always store your Just Wireless® Bluetooth® Headset with the power OFF and make sure it is safely protected. • Avoid storage at high temperatures (above 40°C/104°F) such as in a hot vehicle or in direct sunlight. (Storage at high temperatures can reduce performance and battery life) • Keep the headset or any of its supplied parts from getting wet. • 16 JW_Blue_BT42_Booklet.
BT-42 SKU 08081 REV052014 ©2014 Just Wireless. Bluetooth® and associated marks are each trademarks of independently owned and operated companies. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation.