Installation Instructions

1.Connect the power supply,the wireless charger

indicator turn to blue and keep always on,then

go to standby.

2.Put the wireless charging mobile phone on the

wireless charger,the green LED indicator is always

on and start to charge.When the mobile phone is

fully charging, the blue light turns on for 5 seconds oﬀ.

3.When a metal foreign object is placed in the charging

area of the wireless charger, the FOD function is

activated, and the blue indicator light 1 second ﬂash

1 time， until the charging fault is removed

This device complies with Part 15 of the FCC rules. Operation is

subject to thefollowing two conditions: 1) this device may not cause

harmful interference, and 2)this device must accept any interference

received, including interference that maycause undesired operation.

Note: This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to part 15 of the FCC

Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation.This

equipment generates uses and can radiate radio frequency

energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio

communications.However, there is

no guarantee that interference will not occur in particular installation.

If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

--Reorient or relocate the receiving antenna.

--Increase the separation between the equipment and receiver.

--Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

--Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to operate

the equipment.

Radiation Exposure Statement

This device complies with FCC RF radiation exposure limits set forth

for an uncontrolled environment. This transmitter must not be

co-located or operating in conjunction with any other antenna or

transmitter. During the operation of device a distance of 15 cm

surrounding the device and 20 cmabove the top surface of the

device must be respected.

FCC Statement

Fast wireless charger