SATECHBeacon Testing Illumination and Beaconfig APP User Guide 1. Download and install the App “Beaconfig” On your Android smart phone or iPhone, please search and find an App name “Beaconfig” to download and install in GooglePlay or AppStore. Meanwhile, please switch on the Bluetooth communication. 2. Switch on the beacon A. Before testing our beacons, please first check whether the battery is well installed and the Bluetooth pairing is on. B.
Attention: after powering on a beacon, if you long press the button for 5s-7s again, the SOS function starts working. When you see the SOS notice, you shall click the “Cancel” to switch off this function and quit the App. You can not see any other data when you click the “OK” to keep the function and some repeated SOS notices come up. 3. Scan the beacons with “Beaconfig” Each beacon from SATECH has an unique MAC code pasted with a waterproof paper sticker.
connect the beacon with the App, and you will see a twinkling Green LED light after successful connection. 5. Experience how to program or modify the beacon data When you finish the step 4, you come to experience how to program or modify the beacon data with the demo App. A. SETUP OAD: This is for OTA DFU. Whenever our firmware is upgraded and you need to use the newest version, you can update the beacon by OTA. Restore on: When you click it, the beacon data will be restored factory settings.
Power-Power off: This is for switching off the beacon device without pressing the physical button. SATECHBeacon tags have a physical button, but the button function is only programmed for “Power on” and “SOS”. When you want to switch off the beacon, you can click “Power” and then choose “Yes” in the message interface of “Power off” (“No” means quitting powering off) and meanwhile see a twinkling red LED light.
iBeacon: You can program the UUID (16 bytes), Major (2 bytes) and Minor (2 bytes). For example, UUID: 11223344-5566-7788-9900-112233445566. Attention: you must enter the characters as per the format limit and digit limit, otherwise, the UUID will be neglected to the default value. For example, xxxxxxx(7-digit character)-xxx(3-digit character)-xxxx-xxxx-xxxxxxxxxxx(11-digit character) is a wrong UUID.
URL: You can program an URL (16 bytes) as an example as follow: https://satechbeacon.com. TLM: This is a channel of obtaining firmware version, battery voltage, chip temperature, total broadcast times, total working time and etc. For example: Version: 1.0 Battery Voltage: 3303mV(0x0CE7) Chip Temperature: 24.0℃ Advertisements count: 5127196(0x004E3C1C) Time since power-on: 105Days+22:57:16(0x0574E456) Info: This is a channel of obtaining MAC address, battery level and device name, etc.
C. Refresh the App and signal filter When you need to refresh the current page, you have two methods to achieve that: 1. click the refresh button (see the following screenshot); 2. click the “Edit Filter” and go back, when you hope to scan the beacon at nearer distrance, you shall slide the “RSSI” scroll bar. 6. Declaration and Cautions A.
www.satechbeacon.com Shenzhen Sato Intelligent Technology Ltd Issued by: David Ding Approved by: Tony Cheng Date: 2019-7-15 FCC Statement: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.