User's Manual

Keydous

NJ80-AP

User's manual

Start a New Journey in 2022

Tips:

1.WIFI signal interferes with Bluetooth signal to some

extent, so bluetooth receiver cannot be too close to WIFI

signal source.

2. It is not necessary to insert and remove the shaft body

with great force. When you find that the shaft body needs

great force, it may be misaligned, please stop the operation,

otherwise the hot plug base will be damaged, or the solder

pad will fall off and the PCB will be directly discarded.

Matters needing attention:

Lithium battery is built into the product. It is strictly

forbidden to place the product in high temperature, high

pressure and direct sunlight. If not used for a long time,

please store the keyboard in a cool and dry environment,

and turn off the power switch.

The original charging cable must be used to connect the

USB port of the computer for charging, and the charging

current should be less than 1A.

PAGE 1
Tips: 1.WIFI signal interferes with Bluetooth signal to some extent, so bluetooth receiver cannot be too close to WIFI signal source. 2. It is not necessary to insert and remove the shaft body with great force. When you find that the shaft body needs great force, it may be misaligned, please stop the operation, otherwise the hot plug base will be damaged, or the solder pad will fall off and the PCB will be directly discarded. Matters needing attention: · Lithium battery is built into the product.
PAGE 2
Operation method of bluetooth pairing :(first turn on the power switch at the bottom of the keyboard) ① Hold down the FN+1 key for 3 seconds. The keyboard enters the pairing state, and the digit 1 indicator blinks at short intervals. ② Open mobile device Bluetooth (such as mobile phone), select BT5.0KB (Win7 system select BT3.0KB) ③ The mobile device is connected, and the pairing is complete. ④ Connect to the second device (e.g. computer).
PAGE 3
Tips for installation（Dongle name:2.4G Receiver, model name:RY6010,FCC ID:2A4MRRY6010) 1. To make sure the Dongle installation not be intercepted,please shut down the antivirus software in your PC during the process. 2. If your PC has built-in Dongle ,please disable the device before driver inatallation(press "Fn+4"in the keyboard) FCC Compliance Notice This device complies with part 15 of the FCC Rules.