User's Manual

The 15921N is a new kind of removal alert tag working with remote control
(EG-RC600) and remote alarm receiver (15901R). It is the devices
especially designed for protecting valuable electronic product such as
camera、mobile phone、MP3 etc.
Specification
1 Technical:
Operating voltage……………………………………+3.0VDC (CR2450)
Standby current………………………………………≤10uA
Alarm current…………………………………………≤25mA
Control range…………………………………………≥10cm (EG-RC600)
Remote control range…………………………………≥15m (voltage: 3VDC)
Alarm decibel………………………………………≥85dB/10cm (voltage: 3VDC)
2 Environments:
Operating temperature………………………………0~40℃
Storage temperature…………………………………-20~+60℃
Relative humidity……………………………………5%~95%
3 Dimensions:
Main part………………………………………………80.0×62.0mm×142.0mm
Protection tie Elongate length……………………0.6m
4 fittings:
Remote controller……………………………………EG-RC600
Remote alarm receiver………………………………15901R
Installation procedures
1: fix the 15921N on the table board with screws
2: rip the sheet off the protection block, and cling the glaze of the
merchandise to the protection block firmly
3: insert the pin of the tie into the 15921N, then the 15921N will twinkle
for six times and give of two sounds and at last, the commodity is under
protection.
Attention: 1 the glaze should be flatness, free of moisture and dust
2 the ties shouldn’t be elongated and bumped in excess
Alarm qualification (under ward mode):
1 disconnection:
if the tie is cut, or the pin is dragged out of the jack
or the goods is ripped off the protection block unauthorized,
the 15921N will give of alarm (alarm mode) and send its own
ID number to the 15901R to make it alarm for the
administrators to alert.
2 track the EAS: if the 15921N in the ward mode is close to the electronic
alert system, the 15921N will give of alarm (alarm mode) and
send its own ID number to the 15901R to make it alarm for
the administrators to alert.
Payment function:
If anyone wants to buy the commodity under protection, press
the reset bottom of the remote controller, and then rip the