Installation Instructions

ManualsBrandsShenzhen RenDaTong Electronic Technology ManualsElectronicsDVD suction a top

10” OVERHEAD MEDIA

PLAYER

FCC COMPLIANCE STATEMENT:

This device complies with part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Warning: Changes or modifications to this unit not expressly approved by the part responsible for compliance

could void the user’s authority to operate the equipment.

FCC Radiation Exposure Statement

This equipment complied with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed

and operated with minimum distance 20cm between the radiator & your body.

K6863006 Printed in China

Mopar

OVERHEAD DVD

PLAYER

IMPORTANT CUSTOMER

INFORMATION

–

DO NOT DISCARD

Mopar

is a registered trademark of FCA US LLC.

Bluetooth

is a registered trademark of Bluetooth

SIG, Inc.

DVD-2500 RU

Summary of content (7 pages)

PAGE 1
0” OVERHEAD MEDIA PLAYER ©2019 FCA US LLC. All Rights Reserved. Mopar® is a registered trademark of FCA US LLC. Bluetooth® is a registered trademark of Bluetooth SIG, Inc. Mopar® OVERHEAD DVD PLAYER IMPORTANT CUSTOMER INFORMATION – DO NOT DISCARD DVD-2500 RU FCC COMPLIANCE STATEMENT: This device complies with part 15 of the FCC Rules.
PAGE 2
QUICK START GUIDE 10” Overhead Media Player
PAGE 3
IMPORTANT NOTES Listen to audio through the vehicle’s speakers by switching to the auxiliary mode on your radio. Your Mopar® Overhead DVD Player is designed to give your family years of enjoyment.  Play your favorite CDs or DVDs.   Plug and play a variety of devices through the multiple input ports.   Listen to audio through the vehicle’s speakers and/or with the wireless headphones. Please review the accompanying Owner's Manual to become familiar with all features and operation.
PAGE 4
WIRELESS REMOTE Before using the remote it must be paired to the DVD player. REMOTE PAIRING PROCEDURE When using for the first time, the remote requires two AAA batteries for operation. ① Press the "SETUP" and "REPEAT" buttons together. SR-BT20T Re mo te ② The LED indicator will flash blue and red. ③ Press the "DIMMER" and "EXIT" buttons together on DVD player. FCC COMPLIANCE STATEMENT: This device complies with part 15 of the FCC Rules.
PAGE 5
WIRELESS NOISE CANCELING STEREO HEADSET CHARGE THE HEADPHONES When using for the first time, fully charge the battery. For full charging, it takes about 4 hours. The Bluetooth ® wireless is disconnected during charging. SM-H50BT ① Plug the USB cable into the micro-USB connector on the right. ② Plug the other end into a USB wall charger or computer that is powered on. ➋ FCC COMPLIANCE STATEMENT: This device complies with part 15 of the FCC Rules.
PAGE 6
POWER ON AND OFF To power on ① Press and hold the POWER button for about 2 seconds while this unit is turned off. BLUETOOTH PAIRING PROCEDURE ① Press and hold the POWER button on the left for about 7 seconds. ② The LED indicator beside the POWER button will flash blue and red alternately. ② Make sure that the indicator flashes blue after the ➊ device powered on. To power off ① Press and hold the POWER button for about 2 seconds while this unit is turned off.
PAGE 7
TROUBLESHOOTING If you encounter a problem, please turn the power off, then on again. If the unit is still not functioning normally, please review the items in the following checklist.