User's Manual

Wireless Touch Optical Mouse 雷柏無線光學觸摸滑鼠
Quick Start Guide (V1.0)
See www.rapoo.com/T6/faq for latest FAQs, drivers and quick
start guide. For extensive service,register at www.rapoo.com/register.
Troubleshooting
Do not open or repair this device. Do not use the device in a damp
environment. Clean the device with a dry cloth.
Safety instructions
Copyright
It is forbidden to reproduce any part of this quick start guide without the
permission of Rapoo Technology Co., Ltd.
CE
Declaration of Conformity
We， the manufacturer
Shenzhen Rapoo Technology Ltd., Co.
Fax: [phone]
Declare that the product
Product Name Wireless Touch Optical Mouse
Model No
T6
Complies with the following norms of :
EN 60950-1 2006 / A11:2009
EN 301 489-1 V1.8.1 (2008-04)
EN 301-489-3 V1.4.1(2002-08)
EN 300 440-1 V1.5.1(2009-03)
EN 300 440-2 V1.3.1(2009-03)
The product is in compliance with the essential requirements of
Council Directives 2006/95/EC and 99/5/EC, and the ROHS European directives 2002/95/EC dated on
January 27th 2003 amended by directive 2005/618/EC dated on August 18th 2005.
Manufacturer/Authorised representative
________________________________________
Charles Zou, Manager
R&D Department Date of Issue: Jun. 9, 2011
USB
297×420mm 80g
书纸
正面 反面
5601-06K00-222
請到www.rapoo.com/T6/faq查閱最新常見問題、請到www.rapoo.com/
1620/download下載最新的驅動和快速安裝指南。如需延長服務，請到
www.rapoo.com/register註冊。
故障分析
請不要打開或修理該設備。請不要在潮濕的環境使用該設備。請用幹布擦拭
該設備。
安全提醒
智慧財產權資訊
未經雷柏的許可，禁止複製本快速安裝指南的內容。
안전 지침
이 장치를 열거나 수리하지 마십시오. 장치를 습한 환경에서 사용하지 마십시오.
장치를 마른 걸레로 닦으십시오.
저작권
이 간편 시작 설명서의 어떤 부분도 Rapoo Technology Co., Ltd.의 허가 없이
복제될 수 없습니다.
최근 미국의 소리는 이런 곳, 드라이버 및 퀵 스타트 가이드에 대한
www.rapoo.com/T6/faq를참조하십시오. 광범위한 서비스를 위해,에 등록
문제 해결
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate this equipment. (Example- use only shielded interface cables when connecting to
computer or peripheral devices).
This equipment complies with Part 15 of FCC RF Rules. Operation is subject to the following two conditions:
1) This device may not cause interference and
2) This device must accept any interference, including interference that may cause undesired operation of the device.
Caution!
The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment.
Such modifications could void the user authority to operate the equipment.
NCC 警告語
根據交通部低功率管理辦法規定：
第十二條
經形式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻率、加大
功率或變更原設計之特性及功能。
第十四條
低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，
并改善至無干擾時方的繼續使用。
前項合法通信，指依電信規定作業之無線電信。低功率射頻電機須忍受合法通信或工業、科學及
醫療用電波輻射性電機設備之干擾。
Canada Statement
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil
ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
Declaration of Conformity
Hereby, ShenZhen Rapoo Technology Co., Ltd, declares that this device is in compliance with the essential requirements
and other relevant provisions of Directive 1999/5/EC.
RAPOO
雷柏
Power on
Press
Open
Insert the battery
Please plug the receiver into the USB
port, wait about 3 seconds to use
03041B
2.4G Nano Receiver