Installation Instructions

ManualsBrandsShenzhen qichen lighting ManualsElectronicsLED Cloud Lights

LED Cloud Lights

If any problem when you install, send us email to:

serviceled@hotmail.com

Auto

COLOR

G B

SPEED+

off

MODE+

SPEED+

MODE-

1 2

1H 2H

Inch

12.5

Inch

98.5

Inch

Product Parameters

◆

Size：25 X 12.5 X 11 Inch

◆

Input Voltage

：

AC100-240V 50/60Hz

◆

Output Voltage ：DC12V

◆

Remote Distance：10M

◆

Working Temperature：-20～50℃

◆

Beam Angle:360°

Nylon cable tie

Power cable

Nylon cable tie

Wire clips

X10

Hook

Remote

Power

157.5

Inch

Open the vacuum bag, gently pull the

fireproof cotton with your hand, and

adjust the shape of the lamp close

to the cloud

Insert the accessory connector line

and the lamp connector line in pairs,

and pay attention to the position of

the card slot of the connector

Install the hook, adjust the height, fix the wire

with a cable tie and hang the cable tie on the hook

Tidy up the power cable, turn on the power supply,

and adjust the shape and direction of the lamp

Summary of content (3 pages)

PAGE 1
LED Cloud Lights 12.5Inch 25Inch off Auto MODE+ MODE- SPEED+ SPEED+ R G 1H 2H 3H 4H 1 Wire clips X2 X10 Hook Nylon cable X4 tie Product on B w COLOR 2 X1 Remote X1 Power Power cable X1 ◆ ◆ ◆ ◆ ◆ ◆ Paramete Size：25 X 12.5 X Input Voltage：AC100-240V 50/60Hz Output Voltage ：DC12V Remote Distance：10M Working Temperature：-20～50℃ Beam Angle:360° 11 Inch If any problem when you install, send us email to: serviceled@hotmail.com Installation Instructions 1 2 157.
PAGE 2
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
PAGE 3
Remote Control Mode off On Press this key to activate auto color changing mode,in which color would change automatically and circularly. Auto MODE+ SPEED+ In any state,press these two keys to turn on/off the strip lights. MODE- The mode switch SPEED- When color changing is activated,press this key to increase+ or reduce- the changing speed.there are 10 levels for chosen. When light is on.press these two keys to reduce- or increase+ brightness,there are 10 brightness levels for adjustment.