Operation / Installation Manual MUTE APS MODE ALARM 1 FM/AM 2 3 CLOCK DIMMER VOL 4 5 6 VOL SET MENU Bluetooth AM/FM Waterproof Entertainment Center SP3
Button Locations and Functions Introduction 1 Please take the time to read all of the information in this manual. Familiarity with operation and installation procedures will help you obtain the best possible performance from your new Entertainment Center. 2 WARNING! • FCC REGULATIONS STATE THAT ANY UNAUTHORIZED CHANGES OR MODIFICATIONS TO THIS EQUIPMENT MAY VOID THE USER’S AUTHORITY TO OPERATE IT. MUTE APS • THIS DEVICE IS INTENDED FOR CONTINUOUS OPERATION.
Button Locations and Functions (Continued) 11. Seek Up Button : Radio Mode: Short press to automatically seek for next higher tunable frequency. Press and hold to move into manual tuning mode. Bluetooth Mode: Press to search for the beginning of the next track. 12. SET / MENU Button: Short press to enter and then short presses to toggle between sound adjustments: Bass, Treble, Balance, Fader then DSP: Pop/Rock/ Classic, Boost On/Off and then back to Volume. Use the VOL or VOL to make adjustments.
General Operations Sound Controls Power On: Press the Volume: / MUTE button to turn the unit on. Power Off: MUTE Press the / MUTE button for 3 seconds to turn the unit off. Mute: A short press of the the audio. APS MODE ALARM 1 FM/AM 2 3 CLOCK DIMMER 4 VOL 5 Increase the volume by pressing the VOL Decrease the volume by pressing the VOL button. button.
Sound Controls (continued) Setting the Clock DSP: Press the SET/MENU until the “DSP” (Digital Signal Processor - Equalizer) options appears in the display. The Equalizer presets to choose from are: “DSP OFF”, “POP”, “ROCK” or “CLASSIC”. 1. Press and hold the CLOCK/DIMMER button until the clock appears in the display. MUTE APS MODE ALARM 1 FM/AM 2 3 CLOCK DIMMER 4 VOL Immediately use the VOL desired DSP preset.
Radio Operations Radio Operations (continued) Selecting the Radio Play Source: Press the MODE/ALARM button until “RADIO” appears in the display. Scanning and Automatically Storing Radio Stations: MUTE APS MODE ALARM 1 FM/AM 2 3 CLOCK DIMMER 4 VOL 5 6 Press and hold the APS until the tuner begins to scan forward to the next strong station and then release. The new stations will replace stations that were previously stored in the current band.
Bluetooth Operations Installation Pairing Bluetooth Devices: Installing Entertainment Center (available functions are dependent upon the specific Bluetooth audio device and the audio application) 1. Cut out the mounting hole and drill pilot holes for the screws. 1. Press the button to turn on the SP3. 2. Activate Bluetooth from your mobile device and Select “AquaVibe-SP3” which will, if in range, automatically appear in your list of Bluetooth devices. 3.
Warranty Wiring Left Front Speaker White/Black Wire Gray/Black Wire A White Wire (Front) Gray Wire Right Front Speaker Wired Remote (Optional) Go to www.magnadynestore.com to purchase.
FCC Statement: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.