Operation and Installation Manual RDM TRACK MODE RPT VOL SEL Reset Aux In 1 Charge Only Models: MD-150 MD-250 MD-350 Deluxe Entertainment Center with Docking Station
Introduction Please take the time to read all of the information in this manual. Familiarity with operation and installation procedures will help you obtain the best possible performance from your new Entertainment Center. Warnings • This unit is only IPX5 waterproof when the access door is closed. When connecting a device avoid water getting inside the waterproof compartment. Water in the waterproof compartment may damage this unit, cause electrical shock or fire.
Button Locations and Functions 1 2 3 4 5 6 7 8 10 11 TRACK RPT T 13 RDM RDM MODE 12 TRACK VOL SEL MODE RPT Reset Reset Charge Only Aux In 1 VOL SEL 9 1. Power and Mode Button: Power Button: Press to turn the entertainment center on. Press and hold the button for 2 seconds to turn the unit off. Mode Button: Press to select between input sources: Radio: FM tuner. IPOD: 30-pin connector. (Can be selected only when connected to a device). Aux in 1: 3.5mm jack.
Button Locations and Functions (Continued) 13. USB Charging Socket: To charge a device plug the cable into the USB socket then into the device. Note: The unit will not control the device. The cable will not transfer audio into the entertainment center. 15. 30-pin Connector for Apple Products: Plug the 30-pin connector in an IPOD, ITOUCH or IPHONE. Use the track button to select the desired song. 14. Mounting Straps: Holds your device securely inside the unit.
General Operations Power On: Press the / MODE button to turn the entertainment center on. Power Off: Press and hold the / MODE button for 2 seconds to turn the unit off. RDM TRACK IPOD: 30-pin connector. (Can be selected only when a device is connected). Aux in 1: 3.5mm jack. Aux in 2: Rear RCA connectors. Bluetooth: Wireless connectivity. VOL SEL Charge Only Aux In 1 Selecting a Play Source: Press the MODE button to select between input sources. The source will appear in the display.
Sound Controls (Continued) Bass, Treble, Balance, Fader and Equalizer Control Select the desired sound mode by pressing the SEL button. The modes will be displayed in the following order: Bass, Treble, Balance, Fader, Equalizer, Area Setting, Loudness, Distance/Local and Volume. After 5 seconds of inactivity control reverts back to volume control. Bass: Select the Bass mode by pressing the SEL button and “BAS 0” will appear in the display. Increase the Bass by pressing the VOL button.
Sound Controls (Continued) Mute: Press the button to mute the volume level. Press the button again to restore the volume. Note: If the unit is in either the IPOD or Bluetooth mode pressing the button will pause playback. Press the button again will resume playback. RDM TRACK MODE RPT VOL SEL Charge Only Aux In 1 Using an IPHONE or IPOD Inserting an IPHONE or IPOD into Docking Station: 1. Open the waterproof door. 2. Remove the 30-pin connector from its recessed area. 3.
Using an IPHONE or IPOD Changing the Track: Press the TRACK button to select a higher track. Press the TRACK button to select a lower track. RDM TRACK MODE RPT Charge Only Aux In 1 Track Number VOL SEL Elapse Time IPOD Random Play Selection: The default setting is the Random feature is off. RDM TRACK Random Track Selection: To randomly play tracks press the RDM button until “RDM TRK” appears in the display. The tracks will now play in a random order.
Using an IPHONE or IPOD Lingo Modes: Lingo Mode 4 (default): Devices with iOS 6.1 software or higher the touch screen for music is active. Devices with non-iOS or older versions of iOS software, the touch screen for music is inactive. In lingo mode 4 song information will be shown in the LCD display. Lingo Mode 2: Devices with non-iOS or older versions of iOS software the touch screen is active. In lingo mode 2 song information will not be display. Only play, pause and track buttons are active.
Bluetooth Operation Pairing Bluetooth Devices: 1. Open the Bluetooth setup program on the mobile device and activate the Bluetooth feature. 2. Press the button to turn on the entertainment center. 3. From you mobile device scan for available devices. Select ”AQUAVIBE” to connect to the unit. 4. When the mobile device has been paired “ ” will appear in the entertainment center’s display. 5. Press the MODE button until “BT AUDIO” appears in the display.
Radio Operations Selecting the FM Radio Mode: Press the MODE button until “RADIO” appears in the display. After a brief moment “FM” will appear in the display along with the radio frequency. RDM TRACK MODE RPT VOL SEL Charge Only Aux In 1 Tuning in a Radio Station Using Seek: Press the TRACK button and the tuner will seek up to the next strong station and stop seeking, then start playing.
Radio Operation (Continued) Stereo/Mono Operation: RDM Note: “ST” will appear in the display when a FM stereo station is being received. TRACK MODE For weaker FM stereo stations selecting mono reception usually improves reception. 1. To switch from stereo to mono reception press the SEL button until “STEREO” appears in the display. 2. Press the VOL button and “MONO” will appear in the display. Note: The unit will leave feature programing after 5 seconds of no button activity.
Reset Resetting the System: To reset the microprocessor to the original factory settings use a ball point pen and press the RESET button located in the interior of the waterproof compartment. RDM TRACK MODE VOL SEL RPT Reset Charge Only Aux In 1 Inserting a Battery into Remote Controller Lock Inserting a Battery: Coin 1. Use a coin to unlock the battery cover. 2. Insert the battery with the + side of the battery facing up. 3.
Installation Installing Entertainment Center 1. Use the template included to determine the best location for the entertainment center. Note: The mounting location needs to be a flat surface. 2. Cut out the mounting hole and drill pilot holes for the screws. 3. Mount the entertainment center using the provided screws. Make sure to tighten the screws equally to create a waterproof seal.
Wiring Left Front Speaker White/Black Wire Gray/Black Wire White Wire Gray Wire Right Front Speaker Wired Remote (Optional) External Automotive Type Antenna (Optional) ENT MENU VOL SEL MODE VOL 10 Amp Fuse Right Wiring Harness Model: SPA-HAR (Sold Separately) Black Wires Audio In (Aux in 2) Left Right Gray Wires Audio Out Left Red Wire (+) to 12 Volt Ignition Black Wire Ground Blue Wire Trigger for Amp (+12VDC) Left Rear Speaker Green/Black Wire Violet/Black Wire Green Wire Violet
Warranty ONE (1) YEAR LIMITED WARRANTY Magnadyne Corporation or its authorized agents will within one year from the date of sale to you, repair, replace or refund the retail sales price of said product or any part thereof, at the option of the Magnadyne Corporation or its authorized agents, if said product or part is found defective in materials or workmanship, when properly connected and operating on the correct power requirements designated for the specific product.
FCC Statement: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.