User's Manual

ManualsBrandsShenzhen Powerqi Technology ManualsElectronicsMagnet Wireless Charger

90*65mm

1:1

无线充电器说明书

LC10

128g哑粉纸双面四色印刷

2020.11.17

Input: DC5V 3A, DC9V 2.22A, DC12V 1.67A Charging distance: ≤10mm

Output: 5W/7.5W/10W/15W Conversion: ≥72%

Frequency: 115‒205 KHz NW.: 50g

Dimension: Φ58.6×7.3mm

*20W PD wall charger need to buy separately, please use the connector

adapter accordding to your wall charger USB output port.

① Connect the power adapter to socket.

② Connect adapter to the Type-C interface.

Magnet Wireless Charger

User Manual

Thanks for choosing us！

Speciﬁcation

Connect to Power Adapter

Charging Mode

FCC Warning

This is a smart phone wireless charger that allows you enjoy the fun

of digital products easily.

Please kindly read the user manual before using and keep it for

future reference.

① Make sure the wireless charger dock connect to the power supply.

② Put the magnetic wireless charging phone one the charger, they

will align automaticly.

The device also support wireless charging to other nonmagnatic

wireless charging function device.

This device complies with part 15 of the FCC Rules. Operation is

subject to the following two conditions:(1) This device may not

cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause

undesired operation.

Any Changes or modiﬁcations not expressly approved by the party

responsible for compliance could void the user's authority to

operate the equipment.

This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment

generates uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the

equipment oﬀ and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit diﬀerent

from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for

help.

FCC RF exposure statement:

The equipment complies with FCC radiation exposure limits set

forth for an uncontrolled environment. During the operation of

device a distance of 15 cm surrounding the device and 20 cm above

the top surface of the device must be respected.

FCC ID：2AFP2LC12