User's Manual

ManualsBrandsShenzhen Powerqi Technology ManualsElectronicsDual Wireless Charger

90*65mm

1:1

无线充电器说明书

FD01

128g哑粉纸双面四色印刷

2019.04.12

3-608FD010690A0001

中性

Dual Wireless Charger

User Manual

Input: DC12V,2.5A

Frequency: 110~205KHZ

Dimensions: 200×90×10mm

Charging distance: ≤10mm

Conversion: ≥72%

NW.: 125g

Speciﬁcation

Connect to Power Adapter Charging Mode

Power

Adapter

Notes

连接适配器充电

USB适配器

手机正确充电方式

感谢您购买本产品!

Thanks for choosing us!

规格参数

输入电压：DC12V,2.5A

工作频率：110~205KHz

规格尺寸：200×90×10mm

接收距离：≤10mm

电力转换：≥72%

产品重量：125g

注意事项

双座无线充电器

用户手册

This is a smart phone wireless charger that allows you enjoy the fun

of digital products easily.

Please kindly read the user manual before using and keep it for

future reference.

本产品是一款智能手机无线充电器，能让您轻松体验数码产品的无限

乐趣。

使用本产品前请认真阅读本手册并妥善保存，以备查阅。

① 将电源适配器插在插座上。

② 电源线连接充电板。

③ 充电板待机时指示灯显示绿色。

① 确认无线充电器连接电源，并处于待机状态。

② 将带有无线充电功能的手机正确放置在发射板上，指示灯显示为蓝

色，无线充电器处于充电状态。当移除手机，无线充电器进入待机模

式。

注：使用该产品为三星自带无线充功能的手机充电时，当手机充满后，若手机长时

间未拿开，该手机将保持电量在 100% 状态（补充充电）。

1、请勿挤压或碰撞。

2、请勿自行拆卸或投入火中、水中，避免造成短路漏电。

3、请勿在严重高温、潮湿或腐蚀性环境下使用无线充电器，避免损

坏电路出现漏电现象。

4、请勿与带磁条或者芯片的磁卡（身份证、银行卡等）放置太近，

避免造成磁卡失效。

5、请保持植入医疗设备（心脏起搏器、植入性耳蜗等）与无线充电

器之间的距离至少为20cm，以避免对医疗设备造成潜在干扰。

6、应看管好儿童，以确保他们不将无线充电器当成玩具来玩，以避

免不必要的意外。

说明书涉及图片均为示意图，最终产品以实物为准。

内含：无线充电器、电源适配器、产品说明书。

① Connect the power adapter to socket.

② Power line is connected with the charging plate.

③ The standby indicator light is green.

This device complies with Part 18 of the FCC Rules.

NOTE: This equipment has been tested and found to comply with the

limits for a wireless power charger, pursuant to Part 18 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment oﬀ and

on, the user is encouraged to try to correct the interference by one or

more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit diﬀerent from that to

which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

CAUTION: Changes or modiﬁcations not expressly approved by the party

responsible for compliance could void the user’s authority to operate the

product.

This equipment complies with FCC radiation exposure limits set forth for

an uncontrolled environment. This equipment should be installed and

operated with minimum distance 20cm between the radiator and your

body. This transmitter must not be co-located or operating in conjunction

with any other antenna or transmitter.

① Make sure the wireless charger dock connect to the power supply.

② Put the Qi-enabled smart phone properly on the transmitter, the

indicator light become blue and start charging. The device enter to

standby mode when take away the phone from charging pad.

Note: When Samsung phones which are built-in wireless charging

function get fully charged with this product, if don't move the phone in a

long time, the battery power keeps in fully charged status(supplementary

charge).