Product Specs

Product specification
1. Introduction of car wireless charging function ：
The product could achieve short-range radio transmission by
magnetic induction, Using regulate voltage working mode, applicable to
charging for digital products of 5V 1A, communications, furniture, fire
protection, water proof and other digital products, this product meets Qi
wireless charging standard, compatible with all Qi enabled devices, and
support fast wireless charging.
This product has wide operating voltage (DC 5V-9V) which can
adapt to most USB A adapter and QC2.0/QC3.0 adapter. It has a built-in
40mAh battery that can power the circuit to drive the stepper motor to
open and close in case of power failure;
How to use: Connect the adapter through Type-C cable( standard
cable). It maximum support 5W loads under normal charging mode
when connect to 5V output adapter. And it can achieve 7.5W fast
wireless charging mode for iphone8/iphone8Plus/iphone x and
maximum support 10W loads when connect to QC2.0/QC3.0 adapter.
When the product is connected to the adapter or the car charger, it will
automatically open. When the phone is put on to sense that the phone is
charging, it will automatically clamp the phone for quick charging. When
the phone needs to be taken away, just press the left button or the right
button to open it. If the phone is not taken away within 5 seconds after
opening, it will automatically clamp the phone and continue to charge. If
the phone is not taken away after power failure, you can press the left
button or the right button to open and take the phone;
2. Transmitter pad indicator light working description ：
2.1 Power on: The blue light flashes once, the green light flashes once,
the blue and green light flash at the same time, then turn to the long
green light, enter standby mode;
2.2 Standby: Indicator light will turn green for a long time.
2.3 Charging: Indicator light will turn blue for a long time, remove the
receiver, the indicator light will turn green, enter into standby mode.
The blue and green lights flickered at the same time.
3.Receiver location hints
Tips: The greater deviation distance, The lower charging efficiency
If the receiver coil of phone offset transmitter coil position allowed
distance (± 5mm),the transmitter will not work. It need to put the
phone in the correct position and the device will re-enter the charging
status.
4.Basic Performance Parameters