How-To Guide

1. Open the battery compartment by pressing down on the back of the
mouse(A) then press and slide(B) down. Insert the battery following
the polarity (+/-) marked.
Side key
(Not muted)
DPI Switch(Mute)
1000-1200-1600 (Default 1200)
(Mute)
(Mute)
(Mute)
WinXP/ Win7/Win8/ Win10 etc.
NM9317 / K101A
2.4GHz Wireless Mouse
Frequency:
Operating distance:
Number of keys:
Product Size:
Product weight:
Program name:
Photoelectric IC:
DPI parameters:
Light wake up:
Deep sleep:
How to wake up:
2.4G rate of return:
Face to face test:
Operating voltage:
2.4GHz
8-10 meters (open distance)
5 keys
110*72*35MM
About 66g
Telink TLSR8516
FCT3065-XY
1000-1200 (default)-1600dpi
10 seconds
10 minutes
Key to wake up
125Hz
Black and white paper
1.5V AA*1
FCC Statement
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject
to the following two conditions (1)this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.