Installation instructions Water sensor Module Name: NAS-WS01Z Thank you for your support to our products Please carefully read the installation instructions before you used correctly After reading, please safekeeping Shenzhen Neo Electronic Co.
Product introduction Spilled water detector is a through Z - wave of intelligent security of communication network equipment. In Z - wave network communication, excessive water detector can be any Z - wave and network control device to connect. Z - wave network using radio frequency, is decided by each country or region. In the overflow water detector and the main control device of communication, excessive water detector can only send information, can't receive messages.
Product configuration Water detector The assembly mark Induction of contact stents The probe interface LED lights The code button The battery Induction tentacles screw Screw stopper Item listing overflow detector cell screw screw stopper installation instructions 1pcs 1pcs 3pcs 3pcs 1pcs 3
Z - wave network added Spilled water detection by Z - wave master equipment add water detector to the Z wave in the network。 1). Open water detectors, equipped with batteries, install the equipment in the main control network within the scope of the equipment. 2.) sets the main control device to add learning model (please refer to the specific master equipment operating instructions). 3) fast. Press the button three times to the code, LED lights flashing red light 5 times. 4).
Installation steps bracket installation battery installation will overflow water detectors installed on the bracket installation sensing probe Bracket installation Use screw and screw glue plug fixed bracket Battery installation Open water detectors Install the battery Good water detectors Water will overflow detector installed on the bracket Note: 1. Good water detectors, please note on the assembly. 2.
Warm prompt progr near the easy leakage of water, water will overflow detector probe head should be on the ground water easy to leak. Avoid install the .lampblack, such as water vapor directly smoked the place。 avoid installed in the enclosure, such as alarm sound is not easy to place. avoid install where water immersion. please will overflow water detectors installed on the host network coverage range。 The LED display status 1.
Note: the factory default process, please do not power outages. Battery tips The service life of the battery was designed for two years. The actual capacity in alarm host has showed. When the battery is too low, the phone APP will receive alarm sent by the host "battery is too low, please replace the battery" push information. Replace the battery, please cut off the linkage of the overflow water detectors and other equipment, so as not to cause error alarm or linkage error operation of the equipment.
basic setup command lamp module is determined by the parameters in the adjustable brightness levels. Functions: basic Settings Parameter number: 2 Specifications: 1 byte The available Settings: 0, 1-99 or 255 0 - closed, alarm cancel or shut down power supply equipment 1-99 or 99 - open (binary switch equipment) Light and shade levels (multilevel switch equipment) The default Settings: 99 The battery check command Users can also send BATTERY_GET command query to probe the battery status of overflowing.
* COMMAND_CLASS_ASSOCIATION_GRP_INFO(V1) * COMMAND_CLASS_WAKE_UP(V2) * COMMAND_CLASS_SENSOR_BINARY(V2) * COMMAND_CLASS_CONFIGURATION(V1) 1. The product warranty will be provided by her electronic (shenzhen) co., LTD., shenzhen her electronic co., LTD is located in baoan district of shenzhen west township iron tsai road 44 veterans industrial city 2 6th floor on the east side, zip code 518102。 2.
FCC NOTE: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS OR CHANGE TO THIS EQUIPMENT.