Instruction Manual Power plug Thank you for your support Please read the instruction manual carefully before operating Please keep the instruction manual after reading Model:NAS-WR01Z Shenzhen NEO Electronics Co.
Product Introduction Power plug is an intelligent device that can be controlled remotely by the Z-wave network and the radio wave which has particular frequency. In the Z-wave network communications, Power plug can be connected to any Z-wave main controller. In the radio wave communications, Gateway and Power plug can send messages to each other through the radio waves. Different countries or areas, the radio frequency is different.
Product Configuration Illustration The code button LED Jack Product List Power plug Instruction manual 1pc 1pc Including Sensor (Power plug) to Z-Wave Network The Power plug can be added to the Z-Wave network by pressing the code button. 1) Plug the power plug in the socket. Make sure the device is located within the direct range of the main controller. 2) Set the main controller to the learning mode (see main controller’s operating manual).
Installation Steps Plug the power plug in the socket Plug the load in the power plug Plug the power plug in the socket Plug the load in the power plug
Tips Please do not spray water on the power plug. The on and off of power plug can be switched remotely by mobile phone APP. The load connected with the power plug shouldn’t exceed 2500w to avoid damaging of the power plug. Make sure of that power plug is in the gateway’s network. The status of LED 1. 2. 3. 4. When the power plug is on, LED light keeps being green. When the power plug is off, LED light keeps being out.
Current Load and Energy Consumption This Plug provides line voltage, current load, power consumption and energy consumption measuring. These measurement results are sent to Z-Wave Controller or Z-Wave Gateway. Voltage – The Supply Power Voltage For Plug. Current – The Current for the Electric Device Connect to Plug Consumption. Power – Power Consumed by an Electric Device in an instant, unit: Watt (W). Energy – Energy Consumed by an Electric Device through a Time Period.
Available Settings: 1 – 16 (Ampere). Default Setting: 13(A). 4. Configure maximum Alarm current This parameter defines maximum current, if the current plug provide to load great than this parameter, the plug will send over-current notification to main controller and the LED will be turn RED, but plug cannot cut-off power. This value must be less than parameter 3#. Function: Set Alarm upper current threshold. Parameter Number: 4. Parameter Size: 1 Byte Available Settings： 1 – Parameter #3 (Ampere).
Function: Remember Relay Status Parameter Number: 7. Parameter Size: 1 Byte Available Settings： 0 - 255 0 – Don’t Remember, the relay will keep OFF when Plug Supply Power. Others – Remember the Relay Status. Default Setting: 255. 8. Configure Plug Time switch Function This parameter defines the timer function Enable/Disable. This parameter can be configured with 0 or 1, where 0 means disable time switch function and 1 enable. The time period will be defined in parameter 9#.
* COMMAND_CLASS_SWITCH_BINARY (V1) * COMMAND_CLASS_NOTIFICATION (V4) * COMMAND_CLASS_METER (V4) * COMMAND_CLASS_CONFIGURATION (V1) * COMMAND_CLASS_SWITCH_ALL (V1) * COMMAND_CLASS_BASIC (V1) Guarantee 1. The Guarantee is provided by Shenzhen NEO Electronics Co., Ltd (hereinafter “Manufacture” ) 2. The Manufacturer is responsible for equipment malfunction resulting from physical defects (manufacturing or material) of the device for 12 months from the date of its purchasing. 3.
FCC NOTE： This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS OR CHANGE TO THIS EQUIPMENT.
