Instruction Manual Siren NAS-AB01Z Thank you for your support Please read the instruction manual carefully before operating Please keep theinstruction manualafter reading Shenzhen NEO Electronics Co.
Product Introduction Siren alarm is an intelligent device that can be controlled remotely by the radio frequency. Siren alarm send messages via Z-wave network to the Z-Wave main controller. In the Z-Wave network communications, Siren alarm can be connected to any Z-wave main controller, Different countries or areas, the radio frequencyof the Z-wave network is different.In the communication between the Siren alarm and Z-wave main controller, the siren alarm can both send and receive messages.
Product Configuration Siren Sticker The code button Battery Cover Screw stopper Screw Product List Siren alarm Battery Screw Screw stopper Double-side adhesive Instruction manual 1pc 2pcs 3pcs 3pcs 1pc 1pc
Including Sensor (Siren alarm) to Z-Wave Network The siren alarm can be included to the Z-wave network by pressing on the code button. 1) Disassemble the siren alarm and insert the battery into the siren alarm. Make sure the device is located within the direct range of the controller. 2) Set the controller into the learning mode (see main controller’s operating manual). 3) Quickly, triple click the code button, LED light will flash red. 4)Siren alarm will be detected and included in the Z-Wave network.
Installation Steps Hardware Installation Cover installation Battery installation Cover installation Option One Option Two Fix the siren alarm with Screws Fix the siren alarm with sticker Battery installation Open the siren alarm Installation example Install battery Close the siren alarm
Tips When install the siren alarm, please avoid the noisy places. Please install somewhere easy to find. Do not install in a ventilated position to affect the effect of the siren alarm. Do not install at a wet place to prevent the siren alarm from damaging. When the siren alarms, it would sound and the led would flash red lights. The siren alarm can be controlled remotely by mobile phone App. Association allows for direct communication between Z-Wave network devices.
Restore the Sensor (Siren alarm) to Factory Default Settings Reset procedure will delete all information on the Z-Wave network or Z-Wave controller , and restore the sensor to factory default settings. 1. Remove the sensor’s cover. 2. Make sure the sensor is connected to power source. 3. Press the code button for 10 seconds, LED will flash red for 3 seconds. 4. Release the code button. NOTE When the siren alarm is being restored factory settings, please make sure power source is connected.
Guarantee 1. The Guarantee is provided by Shenzhen NEO Electronics Co., Ltd (hereinafter “Manufacture” ) 2. The Manufacturer is responsible for equipment malfunction resulting from physical defects (manufacturing or material) of the device for 12 months from the date of its purchasing. 3. During the Guarantee period, the Manufacturer shall remove any defects, free of charge, by repairing or replacing. 4. In special cases, when the device cannot be replaced with the device of the same type (e.g.