Installation Instructions

InstallationInstructions
WiFiPIRMotionSensor
UserManual
Fresnellens
Backcover
NetworkSetting
Presstheresetbutton
for5sthenrelease.
2.2M
Validdetectionarea(topview)
1 4
8(m)
Poweronthedevicewith3*AAbatteries,theredin
dicatorflashesslowlyforoneminute.
1 4
8(m)
2.Wallmountedtype
Distribetionnetworkhint:
Openthebackcoverwithscrewdriver
PackingList
WiFiPIRmotionsensor(×1)
3Msticker(×1 Bracket(×1))、
3M胶*2
3M
3M
WiFiPIRMotion
Sensor
UserManual
UserManual(×1)
QCPASS
QCPASS(×1)
Expansiont ubes(×2)、 s(×2)Screw
AAbattery(×3)
(1)Usingscrews：
Fixthebrackettothewallwith
screws
Theninstallthedevicetothebracket
90°
Fixthedevicetobracket
Sticktosuitableplacewith3Msticker.
(2)Mstickerinstallation：
3
M
3
M
Productshouldincludebelowaccessories.
ProductDescription
1.Powerontheproduct.
2.Presstheresetbuttonfor5Sandrelease,thegreen
LEDwillflashfornetworksetting.
Pressthebuttonfor5s-10s,theredLEDisonfor5
secthenturnsoff.Releasethebuttonfornetwork
setting,thegreenLEDflashesduringnetworking.
ThegreenLEDwillbeonfor5sthenturnsoffto
indicatenetworksettingsucceeds.Iffails,the
greenLEDisoff.
3.InstallationInstructions:
(1)Afterpoweredon,theproductwillenterself-checkingstateand
theredLEDwillflashfor60s.
(2)Afterself-checking,theproductenterstestmodefor5minutes.
Whenitdetectshumanmotion,theredLEDflashandsendsan
alarmsignal.
(3)Duringworkingstatus,presssetbutton,theredLEDflashonce,
thenentertestingmode.
(4)Aftertestingmode,thedetectorentersworkingmodeandno
motionstatus.Whenhumanmotionisdetected,theredLEDison
andsendsanalarmsignal.Afteralarm,ifcontinuousmotionis
detected,itwon’tsendalarmsignal.Untilnomotionisdetected
for1minute,itrestorestonomotionstatusandworkingmode.
1.Installationposition:Installtheproductwherepersonsmaybe
detectedtocross.Itisrecommendedthattheproductbeabout
2.2mabovetheground,asshowninthefollowingfigure.
Validdetectionarea(sideview)
Thegrayarea
isthevalid
detection
area.
Cross
3.Notice:
.Makesurenoobstacleindetectionarea.a
.Wirelessdistancewillbeweakenifthereisblocksb
(suchaswalls)betweendeviceandWiFirouter.
c.Installtheproductawayfromobjectsthatmaycause
temperaturechanges,suchastheairconditioner,fan,
refrigerator,andoven.Donotexposetheproductto
thesun.