MT-WN713NM 150M WIRELESS USB MODULE User’s Manual Release 0.
Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna. As long as 2 conditions above are met, further transmitter test will not be required.
Introduction The MT-WN713NM which is based on the RT5370, is a 802.11 b/g/n wireless embedded Mini-PCI module for AP/ Router + AP. MT-WN713NM will be a RF module of AP board. It has greater throughput at longer range. The MT-WN713NM is a green product. Features y y y y y y y y y y y y y Compatible with IEEE 802.11n draft 2.0 standard to provide up to 150Mbps data rate. Compatible with IEEE 802.11g standard to provide up to wireless 54Mbps data rate Compatible with IEEE 802.
Installation y y y y y y Turn on the computer and Insert the Alpha WUS-N10 Driver CD in the CD-ROM drive When the auto run screen appears, click Install Drivers. The Install Shield Wizard window will appear. By default setup will install to the default location: To install to a different location click Browse and specify the location. Select the Program Files folder location The Wireless Connection Wizard will now appear.
Usage Guidelines for FCC Compliance Antenna In order to maintain compliance with FCC regulations,This module has been tested with the following antennas: nix Part Number Antenna Type Antenna Gain DTS Part Number Antenna Type Antenna Gain ANT-2400-01A PCB 1.3 dBi Module Modification The module must not be physically altered in any way. If any connections are made to the module that bypass the module pins, socket, or antenna connector, the FCC modular certification cannot be inherited.