Instruction Manual

Parallax 4000 Wireless Power
B
ank w/ 2-in-1 Cable
Instruction Manual
7121-51
1 x 4000 mAh wireless Power Bank
1 x 2-in-1 charging cable (see above diagram)
1 x Instruction Manual
4000 mAh/3.7V poly-li battery
Input power: DC5V/2A
Output power: DC5V/2.1A
Wireless Output: DC 5V/1A
ON/OFF Button: Press once to view the
remaining power capacity.
Charging the power bank:
Using 2-in-1 charging cable, insert the USB
USB port of a computer, insert the 2-in-1
tip (the side with pins upwards) into power
bank micro input. Then charge begins.
LED indicators will be remained BLUE.
Charging mobile phones and other
electronic devices:
Connect the 2-in-1 cable to your mobile
phone/device. If Android device, the tip with
pins upwards; If iOS device, the tip without
pins upwards. Connect the other end of the
will illuminate BLUE when charging.
When capacity is getting decreased during
charging, the four LED indicators will
Remove the USB cable from your mobile
device when it is fully charged.
Charging Mobile phones and other
electronic devices with wireless output.
Press ON/OFF Button once, BLUE four
indicators should be on to show balance
capacity, the remaining two LED indicators
indicator would wait for 50 seconds to
60 seconds.
When the last indicator displays RED, it
means wireless charging mode. Place a
phone compatible with wireless charging
function on the wireless charging pad
surface and it would charge automatically.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
This device may not cause harmful
interference, and
This device must accept any interference
received, including interference that may
cause undesired operation.
Warning:
approved by the party responsible for
compliance could void the user’s authority
to operate the equipment.
WARNING–When using this product, basic
precautions should always be followed,
including the following:
To reduce the risk of injury, close
supervision is necessary when the product
is used near children.
Do not expose the device to moisture.
Do not use the device in excess of its
output rating. Overload outputs above
Do not use the device if damaged or
explosion or risk of injury.
Do not disassemble the device. Take it to
or repair is required. Incorrect reassembly
or temperatures above 212ºF may cause
explosion.
repair person using only identical
replacement parts.
This will ensure that the safety of the
product is maintained.
Do not overcharge Phone. Unit may get hot
with excessive use. Remove Phone when it
is fully charged. Never charge for more than
7 hours at a time.
1.
a.
b.
2.
a.
b.
c.
3.
a.
b.
(1)
(2)
*
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
•
•
•
•
•
What’s included:
Features:
LED Indicators:
Instructions:
FCC Statement:
SAFETY PRECAUTIONS:
1.
2.
3.
4.
5.
6.
Wireless Charging Pad
Micro USB Input
USB Output
LED Indicators(six)
ON/OFF Button
Type-C Input
MADE IN CHINA
Note: In order to charge devices, use only the
accessory cable or the cable included with your
own device by the manufacturer.
Read all the instructions before using the
product.
Charge the power bank fully before initial use.
The unit’s full performance is achieved only
after 2 or 3 completed charge and discharge
cycles.
13. Attachments on the back of your phone
can impede the effectiveness of the
wireless charger, and lead to overheating.
Please remove attachments from the phone
before charging on this device.