Instruction Manual

Wireless
Power Bank
Instruction Manual
1 x 3,000 mAh Power Bank
1 x USB to Micro-USB charging cable
1 x Instruction Manual
3000mAh poly-li battery
Input power: 5V/1A
Output power: 5V/1A
Wireless Output: 1A/5W
ON/OFF Button: Press Once to check LED
indicators; Press the button twice
to turn OFF power bank.
Charging the power bank:
Using your mobile phone’s USB adapter,
connect a USB cable to your phone’s USB
adapter. Using the Micro-USB connector,
connect the other end of the USB cable
to the input port on the power bank. Plug
the USB adapter into the outlet to begin
charging.
Using your computer, connect a USB cable
to a USB outlet on your computer. Using
the Micro-USB connector, connect the other
end of the USB cable to an input port on the
power bank. Make sure the computer is on
to begin charging the power bank.
Charging mobile phones and other
electronic devices:
The power bank has a USB output port
which has the maximum output current
of 1A.
Connect the Micro-USB cable to your
mobile phone/device using the appropriate
connector. Connect the other end of the
power bank. Your mobile phone/device
should display the status of charging.
Remove the USB cable from your mobile
device when it is fully charged.
Charging Mobile phones and other
electronic devices with wireless output.
To use the wireless charging mode the
mobile device needs to be a wireless
device. If necessary, enable wireless
charging in the settings of your mobile
device. Next simply stick your device to the
wireless charging pad and charging will
start automatically.
WARNING–When using this product, basic
precautions should always be followed,
To reduce the risk of injury, close
supervision is necessary when the product
is used near children.
Do not expose the device to moisture.
Do not use the device in excess of its
output rating. Overload outputs above
Do not use the device if damaged or
explosion or risk of injury.
Do not disassemble the device. Take it to
or repair is required. Incorrect reassembly
or temperatures above 212ºF may cause
explosion.
repair person using only identical
replacement parts.
This will ensure that the safety of the
product is maintained.
Do not overcharge Phone. Unit may get hot
with excessive use. Remove Phone when it
is fully charged. Never charge for more than
7 hours at a time.
1.
a.
b.
2.
a.
b.
c.
3.
a.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
•
•
•
•
•
What’s included:
LED Indicators:
Instructions:
SAFETY PRECAUTIONS:
1.
2.
3.
4.
5.
USB Output
Micro USB Input
Capacity Indicator
ON/OFF Button
Wireless Charging Pad
5
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
This device may not cause harmful
interference, and
This device must accept any interference
received, including interference that may
cause undesired operation.
Warning:
approved by the party responsible for
compliance could void the user’s authority
to operate the equipment.
(1)
(2)
*
Note: In order to charge devices, use only the
accessory cable or the cable included with your
own device by the manufacturer.
MADE IN CHINA
Read all the instructions before using the
product.
Charge the power bank fully before initial use.
The unitʼs full performance is achieved only
after 2 or 3 completed charge and discharge
cycles.
13.Attachments on the back of your phone
can impede the effectiveness of the
wireless charger, and lead to overheating.
Please remove attachments from the phone
before charging on this device.
FCC Statement:
MSL-W005Q