Instruction Manual

UVC Sterilizer w/ Wireless
Power Bank
Instruction Manual
MSL-M6023Q
1 x UV Sanitizer w/ Wireless Power Bank
1 x USB-A to Type-C Cable
1 x Instruction Manual
Capacity: 10000mAh/3.7V/37Wh
Type-C Input: DC 5V/2A
USB Output: DC 5V/2A
Wireless Output: 5W
a wireless charging device or there is an
object between the device and charging
surface interfering with the charging
process.
Using the UV Sanitizing Function:
Press the UV-C Lights Button(4) to turn on the
BLUE when UV Sterilizing has started.
The UV lights will turn off itself after 5mins,
or press button(4) to turn off UV lights.
(There will be a tick sound and the LED will
turn off once sterilizing is done.)
DO NOT LIFT UP THE COVER(7) ONCE THE
SANITIZING PROCESS HAS STARTED:
The UV LED will automatically shut off
when you open the lid during sanitizing
process.
explosion or risk of injury.
Do not disassemble the device. For
professional. incorrect reassembly may
or temperatures above 104°F may cause
explosion.
use only identical replacement parts to
ensure product safety.
Attachments on the back of your phone
can impede the effectiveness of the
wireless charger, and lead to overheating.
Please remove any attachments from the
phone before charging on this device.
Charging the Powerbank:
Be sure to charge the powerbank fully
before usage.
Connect the provided charging cable to a
power source and to the Type-C port on
the powerbank(6).
Once connected the LED Indicator will
Charging Mobile Phones and other
Electronic Devices:
Connect the charging cable to your mobile
phone/device using the appropriate
connector.
Connect the USB part of the
cable to the USB-A Output(5) of the
powerbank. The LED will glow WHITE
when charging.
Remove the USB cable from your mobile
device when it is fully charged.
Wireless Charging Mobile phones and
other electronic devices:
Press the Powerbank ON/OFF button(3)
to turn on the wireless charging function.
The 2nd LED Indicator will glow GREEN
once the power bank is in wireless
charging standby mode.
Place wireless charging supported mobile
device on the charging surface(8), the
2nd LED will glow RED when device is
charging.
Note: When wireless charging, if 2nd LED
1.
•
•
•
2.
•
•
•
3.
•
•
**
1.
2.
3.
4.
5.
6.
7.
8.
•
•
•
•
4.
•
•
**
9.
10.
11.
12.
13.
UV-C Lights
LED Indicators
ON/OFF Button
UV-C lights ON/OFF Button
USB-A Output Port
Type-C Input Port
Cover
Wireless Charging Surface/
Sanitizing Compartment
General Lights
What’s included:
Functions:
Instructions:
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
This device may not cause harmful
interference, and
This device must accept any interference
received, including interference that may
cause undesired operation.
Warning:
approved by the party responsible for
compliance could void the user’s authority
to operate the equipment.
(1)
(2)
*
FCC Statement:
MADE IN CHINA
WARNING-When using this product, basic
precautions should always be followed:
Read all the instructions before use.
Never store or use this product in
temperatures below 32°F(0°C) or above
115°F(45°C).
Do not overcharge your phone. The
unit may become hot under excessive
use. Remove your phone once it is fully
charged. Never charge your phone for
more than 7 hours at a time.
The unit will only achieve full performance
after 2 or 3 completed charge and
discharge cycles.
To reduce the risk of injury, close
supervision is required when the product is
used near children.
Do not expose the device to moisture.
Do not use the device in excess of its
output rating. Overload outputs above the
Do not use the device if damaged or
•
1.
2.
3.
4.
5.
6.
7.
8.
SAFETY PRECAUTIONS:
ON/OFF Button(3): Press once to view the
remaining power capacity.
•
LED Indicators:
9.
9
EPA Est. NO.: