User Manual

1
Blackstone Indoor Remote-Controlled Outlets
Set of 3 Indoor Remote Outlets
Wireless Remote Control MW001, WRCS1-3
Indoor Power Stake and Remote Package Includes:
(3) Wireless Wall Outlet Receivers (Receiver Units)
(1) Four Button Handheld Remote Control (Sender Unit)
(1) Battery Type: CR2032
Features:
Blackstone Indoor Remote-Controlled Outlets operate on a radio frequency and are not dependent on line of sight. They will perform regardless of
walls, doors, and floors.
Operation:
Remove Pull Tab from Battery Chamber
In order for the remote to function, you need to remove the protective insert from the handheld remote control to allow the battery to make proper
contact with the handheld remote control.
Plug in Receiver Units
Plug the individual wall receiver units into any standard grounded indoor 115V/60Hz wall outlet. Please Note: The Indoor Remote-Controlled Outlets
require a grounded outlet. If you do not have an indoor grounded outlet, contact your electrician to upgrade your electrical system for your safety.
Operation and Safety
Use only 1 Indoor Remote-Controlled Outlet per AC outlet. A distance of at least 24 inches should be maintained between individual receiver units.
Do not overload an individual Indoor Remote-Controlled Outlet beyond 1800 Watts. Reasonable care should be taken to ensure the Receiver Unit is
correctly inserted into the wall outlet. For indoor use only.
This product is for residential use only and not intended to be used outside of the limits noted above. Should use occur outside of the manner
prescribed in these instructions any and all warranties conveyed with this product shall be immediately void and Blackstone International, Ltd. shall
not be liable for any such improper use, which could cause serious damage to persons and/or property.
Receiver Function:
The power button is located on the front of the receiver. The power button can be used to manually switch the receiver on and or off
independently of the included handheld remote control. A blue LED light will appear around the power button when the receiver is plugged in. If no
lights appear in the clear ring around the power button, check to make sure that the power for your wall outlet is turned on.
Remote Function:
The remote controls each receiver included in this package. The red LED light on the front of the remote indicates when the remote is in use. Each
button corresponds to a specific receiver. Example: remote button 1 controls receiver 1. Pressing the remote button for the corresponding receiver
will cause the receiver to turn on and or off. Pressing the remote button that states “ALL” will turn all 3 receivers on or off.