Parts List/Tune Up Info

2AZBU-SM651RX_Tune Up Procedure

Measurement Procedure:

1. Set the device to operational voltage and on a predefined channel in a special test mode.

2. The actual output power is measured at several power levels.

3. The gain factors of each individual device are adjusted until the target value is met. The

appropriate gain control settings for each output power level are stored in each device

individually (for each power level). The user has no possibility to change these settings

later on.

4. The maximum gains of each individual device are adjusted and measured until the target

value is met. The production target power with tolerance compiles with the maximum

power in test report.

Average Power Output:

Mode

2.4G custom

Channel

Low

Mid

High

GFSK(1Mbps)

10±1dBm

11±1dBm

Then these appropriate rated RF output power settings are stored in each device

individually. The user has no possibility to change these settings later on, and during

manufacturing each device will be individual calibrated. The measurement is done in

fully calibrated setup, which is based on the base station simulator. Furthermore, the

highest power level is verified afterwards in a call measurement on three

channels(low, middle and high).

PAGE 1
2AZBU-SM651RX_Tune Up Procedure Measurement Procedure: 1. Set the device to operational voltage and on a predefined channel in a special test mode. 2. The actual output power is measured at several power levels. 3. The gain factors of each individual device are adjusted until the target value is met. The appropriate gain control settings for each output power level are stored in each device individually (for each power level). The user has no possibility to change these settings later on. 4.