User's Manual

ManualsBrandsShenzhen Mindray BIO-Medical electronics ManualsElectronicsBluetooth Low Energy Module

1.1 General

Decri

Panlink module consists of a BT module, crystal and antenna connector. This module can

change UART signal to wireless signal using Bluetooth low energy technology. This module uses

external antenna via a Antenna connector.

Panlink communication type is piconet, which means Panlink transfers data to another

Panklink(one is master, the other one is salve).

When transfering data from master to slave, data was given to master by UART. Then

master panlink controls signal, frames, radiation power and transmits them via the antenna to slave

panlink. Slave panlink get RF signal via the antenna and resolve it to data.

When transfering data from slave to master, data was given to master by UART. Then slave

panlink controls signal, frames, radiation power and transmits them via the antenna to master

panlink. Master panlink get RF signal via the antenna and resolve it to data.

1.2 Block diagram

1.3 Interface and pin definition

No.

Pin name

Type

description

1 to 8

No use

Debug clock

Debug data

Summary of content (5 pages)

PAGE 1
.1 General Decription Panlink module consists of a BT module, crystal and antenna connector. This module can change UART signal to wireless signal using Bluetooth low energy technology. This module uses external antenna via a Antenna connector. Panlink communication type is piconet, which means Panlink transfers data to another Panklink(one is master, the other one is salve). When transfering data from master to slave, data was given to master by UART.
PAGE 2
11 SLEEP_OUT/P3_0 O Wakeup out 12 VDD Power Power in 13 GND Power ground 14 Reset RSTN Reset in 15 Wake/P0_3 I Wake up input 16 UART_RXD0 I Uart in, baud rate is 115200 17 UART_TXD0 O Uart out, baud rate is 115200 18 nCS1/CTSn1/P1_2 I/O Reserved 19 CLK1/RTSn1/P1_3 I/O Reserved 20 MOSI1/TXD1/P1_1 I/O Reserved 21 MISO1/RXD1/P1_0 I/O Reserved 22 CD O Module detect pin 23 RF Connector RF Connect to antenna 1.
PAGE 3
range Operational -20 +70 temperature range 1.5 Wireless specifications Protocol：Bluetooth low energy 4.0 Modulation mode：GFSK Operating frequency：2402 ~ 2480MHz(40 channels) Channel spacing：2MHz Wireless baud rate(data rate)： 1Mbps Output power (transfer power)： Data security ： 128bit AES ≤2.5mW 1.6 Mechanical and package description Dimension is 9.6mm*12.9mm*2.3mm, and package type is SMT.
PAGE 4
This device and its antenna must not be located or operating in conjunction with any other antenna and transmitter. This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
PAGE 5
connected. -Consult the dealer or an experienced radio/TV technician for help Important announcement LABEL OF THE END PRODUCT: The final end product must be labeled in a visible area with the following" Contains FCC ID: ZLZTDBTFE ". The FCC part 15.19 statement below has to also be available on the label: This device complies with Part 15 of FCC rules.