User's Manual

Model:MD-210R
Wireless sending distance(open area):inset
antenna 150m.
Code: 28-digi t ID, 8-digit function code, 36
digits data code in total
Working frequency: 433MHz
(optional)
Working voltage:3V lithium battery
Battery life: about 1 year
Current: static 5uA, alarm:7-12mA (433MHz)
static 5uA, alarm:35-45mA
Note This product use Cr123 lithium battery no battery set in when leave factory please set in
battery before using.
1 Press lightly the snap near the led, and open the cover;
2 Set in battery with right positive and negative poles;
3 code with the panel
A Set the wireless control pane at "auto code" mode.
B Let MD-210R enter working mode parallel put transmitter and magnetic stripe together,
move the magnetic stripe at the moment of pressing the ensure key on the panel and let the
detector send wireless signal. Then the panel will study the code of detector.
Product appearance
When use as wireless detector, do
not mount near strong magnetism
item.
Do not mount at the loose placeDo not mount on the place possiblely to be
destroyed outdoor.
Indication LED
Transmitter
Magnetic
stripe
Alarm output: alarm, tamper
3.2 Installation
Pay attention to these following points.
3.3 Installation introduction
The MD-210R is a fully supervised mini style magnetic
contact transmitter. It features door/ window close/open
instant alarm function. It can be connected to the control
panel. It can transmit strong wireless signal, having
strong intensity in 15m area. Pleas code it to the control
panel before using, enrolling the only one address code
to the control panel. When the distance between the
magnetic stripe and transmitter beyond 2.5cm the
transmitter will send alarm information to the panel. This
detector can change wired signal to wireless signal,
1. Introduction
A. Adopted low consumption CPU
B. Adopted unique Mutil codes
C. Auto status report
Buzzer
The installation guide for users of MD-210R
wireless magnetic switch
D. Anti-lost report
E. Open door/window indication
Status report after fist electro motion or reset the
detector the magnetic switch report the working status
to the control panel separately after 30 seconds, 2
minutes,6minutes. And report working status every
two hours to the control panel.
Color: White
Working Temeprature:-10 ~50
Dimesion:81(L) 32(W) 25(H)mm
Magnetic stripe:74.5 (L) (W) (H)mm
2. Specification
3.1 Main functions
3.The main function and installation
Working as a transmitter.