BRAND Radio MODEL NO: MW-1473
IMPORTANT SAFETY INSTRUCTIONS When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in these instructions and on the unit. Water and Moisture The unit should not be used near water.
Lightning and Power Surge Protection Unplug the unit from the wall outlet. This will prevent damage to the product due to lightning and power-line surges. Overloading Do not overload wall outlets, extension cords, or integral convenience receptacles as this can result in a risk of fire of electric shack. Damage Requiring Service This unit should be serviced by qualified service personnel when: Objects have fallen into or liquid has been spilled into the enclosure. The unit has been exposed to rain.
LOCATIONS OF CONTROLS FRONT VIEW TOP VIEW 3
BACK VIEW BOTTOM VIEW 4
1. ALARM 1 ON/OFF Switch 2. ALARM 2 ON/OFF Switch 3. FUNCTION Switch: FM, AUX, BT 4. VOLUME Knob 5. Power On/ Battery charging indicator 6. LCD Display / Button 7. - Press and hold this button to toggle between “Power On” and “Standby” mode. - In Radio mode: to select the preset stations in sequence - In BT mode: to play/ pause current playback 8. ALARM Button - In off mode: Press to set the alarm. 9. TIME Button - In off mode: Press to set the clock time 10.
13. SNOOZE Button - To activate the snooze function when the alarm is activated - To select LCD backlight Bright/DIM Level 1/DIM Level 2/OFF. 14. Built-in Microphone 15. FM Telescopic Antenna 16. DC 5V Jack 17. 3.5mm AUX-IN Jack 18. Battery Cover 19. Battery locking screw = Unlocked = Locked BATTERY INSTALLATION 1.) Use a coin to rotate the battery locking screw 90 degrees to unlock the battery cover. 2.) Remove the battery cover with your fingers. 3.) Follow the polarity to install the accompanied 3.
Caution - Only use the supplied power adaptor for this device. Do not use for other devices. - Only use the original AC adapter. This adapter has been specially designed for the accompanied battery in order to gradually charge the battery. Any other adapter may shorten the battery life or can damage it or the device. Note: Disconnect from mains power supply during longer periods of non-use.
3. Short press / button to search forward or backward radio station and stop automatically. / button for searching radio frequency 4. Press and hold backward or forward and store the station automatically. Notes: - The unit can store up 50 FM stations automatically for easy recall at any time. Recalling Stored Preset Stations - Press button on the unit, the memory channel number ”01” will flash, press again to select the channel number you desire station.
Pair the Speaker 1. If you haven’t paired this unit with a device, or the paired devices list is empty, pairing mode is activated. 2. Activate Bluetooth on the compatible device, and set it to search for compatible devices. 3. Select the speaker name: “MW-1473” from the list of found devices. Tips: Only one playback unit can be connected to the speaker. If the speaker is already connected to another playback unit, the speaker will not appear in the BT selection list. 4.
Using the unit as a Handsfree Bluetooth Speakerphone 1. Link your cell phone to the radio via Bluetooth as described above. 2. When receiving an incoming call on your cell phone, short tap the button on the unit to switch the incoming call from cell phone to the speaker. Complete your call using the built-in microphone and speaker. 3. Adjust the volume control of your cell phone to obtain the desired sound level. 4. To end the call, just tap the button again, the call will end.
SETTING AND USING THE ALARMS Clock Setup Setting the Time Manually 1. Press and hold the “TIME” button during power off mode to access time setup, the hour digit will flash. 2. Press or button to adjust the hour, then press TIME button to confirm the hour. The hour digit will stop flashing and the minute digit will start to flash. 3. Press or button again to adjust the minute, then press TIME button to confirm the minute. The minute digit will stop flashing and the day of the week icon will start to flash.
from radio, Buzzer appeared. 3. Press the Alarm Button until alarm hour digit flashes on the display. or Button to adjust the hour, press ALARM to confirm Press the hour. The hour digit stops flashing and the minute digit starts to flash. 4. Press or button again to adjust the minute, then press ALARM button to confirm the minute. The Nap alarm will be active only for once, In Nap Alarm mode, it can’t select the week in Nap alarm. Note: .
Sleep Timer Setup - While listening to Radio/ AUX, press and hold “SLEEP” button until “sleep” icon start to flash, press Sleep button to adjust the sleep timer from “90/80/70/60/50/40/30/20/10/00”minutes. After adjusted the sleep timer, just wait the ”sleep” icon stop flash to confirm setting. -when the sleep timer is active, press and hold sleep button to show the current sleep time, press again to adjust it again to modify the setting.
Pairing does not work Bluetooth can not be connected Poor sound quality from a ® Bluetooth device Audio source is switched off Bluetooth is switched off at the audio source. Bluetooth version is not supported. Bluetooth device is almost out of range of the MW-1473 Check whether the source supports the protocol. Switch on the audio source Switch on the Bluetooth function in the audio source. Use a different playback unit.
The right to make technical and design modifications in the course of continuous product development remains reserved. This device has been tested according to all relevant current CE guidelines, such as electromagnetic compatibility and low voltage directives, and has been constructed in accordance with the latest safety regulations. FCC Statement: This device complies with part 15 of the FCC Rules.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help. Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.