User's Guide

User’s Guide for
Battery WiFi Camera
Product Features
Working Temperature
Storage Temperature
-10~ 55℃
-20~ 60℃
Lens
Infrared LEDs
PIR Motion Sensor
Storage
Connectivity
Power consumption
Battery
USB
Video Compression
Voice Intercom
Video resolution
FOV/130°Wide-angle lens (4Glass)
4~6 meters PIR distance
Up to 128GB Micro SD card
802.11b/g/n Wi-Fi@2.4G
2x18650 batteries
DC5V
10 pcs Infrared LEDs with 8 meters
ash distance
60 meters (open space without
obstacle)15 meters (indoor)
H.264
Two-way audio with noise
cancellation
1920*1080@15fps
Product Specication Sheet
Wi-Fi distance
Step 2: Install anchors (on stucco, brick or concrete)
On stucco, brick or concrete, use the bit to drill one
holes in your wall, and install the anchors.install
the base bracket on the wall
2x18650 batteries work regularly for 2~4 months
FHD Megapixels collocated with wide-angle lens
Support mobile phone remote fast wake-up within
6 second
2.4G Wi-Fi connection
Support PIR motion detection, when someone hovers
at the door, it will send push alerts to your mobile phone
immediately
With IR-cut, it can switch automatically and it is
clearly visible at both day and night to keep your
home and family safe
Step 1: Please put the ip switch to “open”position and
open the cover, then Install 18650 battery and Mirco-SD.
(Please notice the polarity of the battery). Press the
Reset button long until you hear the "system reset"
prompt from the camera speaker.
Step 3: Align the device to the base bracket and hold it, then
adjust the appropriate angle, the installation is nished
尺寸：280x100mm
18 650
①
②
③
④
⑤
①Reset button
②Mirco-SD card
③Power button
④18650 Battery
⑤Flip Switch
Install your camera
Product Design
⑥
⑦
⑧
①
②
③
④
⑤
①Lens
②Mic
③Light sensor
④LED
⑤Motion detection sensor
⑥Charge LED
⑦USB interface
⑧Speaker
Charge LED: Charging in Red; Full in Green.
Support to power by USB port
Standby 200uA
Working 260mA
Notes:
1. USB interface is only used as power supply.
2. The mobile phone connects to the Wi-Fi of the
home router, and the mobile APP can generate
a QR code that made of router Wi-Fi name and
password. The product recognizes the QR code
through the lens on the product, and the product
is automatically connected to the router and
server after identication. At this time, the APP
also nds the product through the server, and the
APP can control the operation of the product
through the network.
Note: Please notice the
polarity of the battery.
Please full charge this
camera before using it
for the rst time.