User's Manual

LBS18 user manual

1. Location of controls

A. quick press：previous song long press：increase volume

B. Quick: play/pause

C. quick press：next song long press: decrease volume

D. long press: ON/OFF quick press: answer/end call double press: dial/reject call

E. AUX-IN

F. USB charging port

2.Pair the headphone with a Bluetooth enabled device

Turn the headphone On by long press the power switch, the LED indicator light will quickly blink

BLUE.

Keep your Bluetooth headphone and Bluetooth enabled device within 3feet of each other during the

pairing process, set your mobile phone or other Bluetooth enabled device to search for Bluetooth

devices.

When the Bluetooth enabled device finds the headphone, select” PBT98”from the list of found

devices. If required, enter the password 0000.Select Ok or Yes to pair with your device.

After a successful registration, the LED indicator light will slowly blink BLUE.

Note: if you would like to connect the headphones to another device, you must unpair the

headphones from the currently paired device first. On your device’s Bluetooth settings, select

“PBT91”, then select “unpair”. When the headphones have been unpaired, it automatically goes

into pairing mode again.

3.using as a wired headphone

Connect the one end of the included 3.5mm Aux cable to the Aux In jack on the headphone, and the

other end of the cable to an external device’s headphone jack (smartphone,tablet,computer,or MP3

player).Open a media player on your device and click on play to start playing your music. Use the

controls on your connected device to control music playback and volume.

PAGE 1
LBS18 user manual 1. Location of controls A. quick press：previous song long press：increase volume B. Quick: play/pause C. quick press：next song long press: decrease volume D. long press: ON/OFF quick press: answer/end call double press: dial/reject call E. AUX-IN F. USB charging port 2.Pair the headphone with a Bluetooth enabled device Turn the headphone On by long press the power switch, the LED indicator light will quickly blink BLUE.
PAGE 2
4. Charging the Bluetooth headphone Connect the small end of the Micro USB cable to the charging port on the headphone. Connect the large end of the Micro USB cable to your computer’s USB port or an AC adaptor (not included). The LED indicator light turns RED when charging. It will turn off when fully charged. 5. FCC warning Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.