User's Manual

MagBar User Manual
1, Choose a proper position on the wall to install the
MagBar.
2, Attach the MagBar wall mount to the wall and mark
the four holes on the wall with a pencil.
3, Use a percussion drill to punch the holes in the
position where the marks are previously marked.
Compatibility Notice
The PITAKA MagBar will only wirelessly charge Qi
supported phones with a proper PITAKA MagCase (Pro),
including MagCase (Pro) for iPhone 8/8 Plus/X/Xs/XR/Xs
Max and Samsung Galaxy S10e/S10/S10+/S9/S9+/S8/S8+/S7
edge.
Your phone cannot be attached on the MagBar when you
use an other case or stick metal plates on your phone.
Do not use the MagBar to charge your wireless charging
devices that are not Qi-compatible.
Installation Guide
4, Hammer the expansion bolt into the wall hole. Make
sure they are flushed with the wall surface.
Notice: If you are installing the MagBar to wood/ plasterboard wall,
you can just skip this step.
5, Align the wall mount hole with the punching position.
Keep the side with the arrow face to the user and the
arrow should face up. Use a screwdriver to install the
screws and fasten the wall mount.
6, Align the MagBar with the wall mount and buckle up
the two. Press down the MagBar and slide it to the left.
Then MagBar Installation is completed.
Notice:
If you are not using the PITAKA MagCase. You can
attach the metal plate (Included in the package. Scan
below QR code for the alignment paper to help with
locating the metal plate.) to the back of your phone case
or phone to be compatible with it. But we strongly
recommend you to use MagCase together with MagBar
to optimize the seamless carrying experience. Use the
code “PITAKA10” (expires after Dec 31, 2019) to get a 10%
discount for your MagCase now.
Notice: Make sure the side without the arrow is faced to the wall
and the arrow is faced up.
Notice: If you are installing the MagBar to concrete/brick wall, it’s
recommended to use a 6mm-diameter drill and the recommended
drilling depth is 30mm;
If you are installing the MagBar to wood/ plasterboard wall, it’s
recommended to use a 2mm-diameter drill and the recommended
drilling depth is 5mm.
MagBar x 1 Wall Mount x 1 Charger x 1
Dual Type C Cable x 1 Screws x 6 Expansion Bolt x 6
User Manual x 1
User Manual
Package Contains
1 2 3 4 5
Metal Plate x 2
Compatibility Notice
Package Includes
Quick Guide
Specs
Warranty
Exclusion
Important
Customer Support
FCC Warning
1
1
2
8
9
9
10
10
11
Contents
FCC ID: 2ARI5-MB1001