User's Manual

1. Product Structure

1. Power Switch 2. 2.4G Indicating Lamp

3. Channel Selection Button 4. Test Button

5. Battery Compartment 6. Hot-shoe Contact

7. Lock Ring 8. Hot-shoe 9. Sync Socket

WT-U Flash Trigger

User Manual

Note: The flash will be triggered only when the flash and

trigger are in same channel.

3. 2.4G Channel Instruction

4. Specification:

Model: WT-U Channel: 15 channels Net Weight: 38g

Transmission Distance: 50 m Wireless Frequency: 2.4G

Power Source: 23A 12V alkaline battery

2. Instruction

1. Install the battery in the trigger. Remove the battery

cover, make sure the battery positive and negative polarity

is correctly inserted in the battery compartment, then close

the battery compartment.

2. Set the hot shoe of flash trigger WT-U on the cam-

era's hot shoe, switch the trigger power on, press the

selection button of trigger and then set same channel

as the flash, press the test button on the trigger to

trigger the flash.

3. If the camera does not have hot shoe, use the Sync ca-

ble to connect the trigger and camera. One side connecting

the sync socket of trigger, another side connecting the PC

socket of camera. Press the shutter button of camera to

trigger the flash.

● Specifications and design are subject to change without notice.

Thank you for purchasing this product

Before use, please read this user manual carefully in

order to ensure your safety. Keep it properly for refere-

nce in future.

PAGE 1
WT-U Flash Trigger User Manual 2. Instruction 1. Product Structure 3. 2.4G Channel Instruction 1. Install the battery in the trigger. Remove the battery cover, make sure the battery positive and negative polarity is correctly inserted in the battery compartment, then close the battery compartment. 1 9 2 3 6 7 4 8 5 1. Power Switch 2. 2.4G Indicating Lamp Thank you for purchasing this product 3. Channel Selection Button 4.
PAGE 2
Federal Communications Commission (FCC) Statement. This device complies with part 15 of the FCC Rules. Operation is subject to the following twoconditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.