Users Manual

ManualsBrandsShenzhen Kuibu Electronic ManualsComputers & AccessoriesKeyboard kit

Electrical parameters

1.1.11 Charging voltage: 5V+-0.25V

1.1.12 Charging current: 300-500mA

1.1.13 Working current in constant light mode: less than 250mA

1.1.14 Turn off the backlight: 12mA

1.1.15 Sleep mode current: 0.05-0.25mA

Drive related

1.1.11 Macro configuration: default 3, factory default configuration 0

1.1.12 Main backlight: 22 by default, factory default light wave

(Customized lighting, sound rhythm and light shadow only support drive control)

1.1.13 Button sensitivity: 10 gears by default, 1 gear at the factory

1.1.14 Sleep settings: Bluetooth off backlight, Bluetooth deep sleep,

2.4G off backlight, 2.4G deep sleep

Factory setting: 2 minutes 30 minutes 2 minutes 30 minutes

Setting range: 1-60 minutes, 10-60 minutes, 1-60 minutes, 10-60 minutes

Fn layer: default 1 layer

Onboard macros: The maximum limit supports 50 macros, each macro

supports 64 characters

Bluetooth connection mode

1.1.11 Bluetooth mode:

Summary of content (4 pages)

PAGE 1
Electrical parameters 1.1.11 Charging voltage: 5V+-0.25V 1.1.12 Charging current: 300-500mA 1.1.13 Working current in constant light mode: less than 250mA 1.1.14 Turn off the backlight: 12mA 1.1.15 Sleep mode current: 0.05-0.25mA Drive related 1.1.11 Macro configuration: default 3, factory default configuration 0 1.1.12 Main backlight: 22 by default, factory default light wave (Customized lighting, sound rhythm and light shadow only support drive control) 1.1.
PAGE 2
Bluetooth: FN+1/2/3 long press 3S to enter the corresponding channel pairing mode of Bluetooth,BT1 channel 1-blue, flashes quickly when pairing, flashes slowly when reconnecting, the pairing is successful and always bright blue,BT2 channel 2-cyan, it flashes quickly when pairing, and flashes slowly when reconnecting, the pairing is successful and always bright cyan,BT3 channel 3-purple, it flashes quickly when pairing, and flashes slowly when reconnecting. If pairing succeeds, it will always light purple.2.
PAGE 3
is disconnected, MCU enters low power sleep),When the button is pressed (no code is sent), the red light in "LED Definition 2" flashes slowly at 1 Hz for 5 times to indicate low power.
PAGE 4
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.