User's Manual

Specification of KL180-4 KL180-2 KL180C-4 KL180D-4

KL180E-4

Parameter:

Working Voltage：DC12V

Working Current：10mA

Frequency：433.92MHz

Modulation：ASK

Temperature：-20-55℃

Dimension：55*30*13.5mm

Weight : 28.2g

Encode type: Learning code

Operation Method:

1. Match code:

Hold learning button and learning indicator light blinks, then press any buttons of remote control,

if indicator lights flashes 3 times, match code successfully. Maximum 80 remote controls can be

matched.

2. Delete code:

Hold learning button till the indicator LED lights and then off, delete successfully.

3. Set working mode:

S1 & S2 program the sequence as follows:

Jumper on S1→ Toggle

Jumper on S2→ Latched

No Jumper on S1 &S2→ Momentary

PAGE 1
Specification of KL180-4 KL180-2 KL180C-4 KL180D-4 KL180E-4 Parameter: Working Voltage：DC12V Working Current：10mA Frequency：433.92MHz Modulation：ASK Temperature：-20-55℃ Dimension：55*30*13.5mm Weight : 28.2g Encode type: Learning code Operation Method: 1. Match code: Hold learning button and learning indicator light blinks, then press any buttons of remote control, if indicator lights flashes 3 times, match code successfully. Maximum 80 remote controls can be matched. 2.
PAGE 2
Working Mode: 1. Non-lock/Momentary: Press remote button A, the corresponding relay on the receiver is on; release button A, the relay is off, the same as others. 2. Self-lock/Toggle: Press remote button A, the corresponding relay on the receiver is on; press button A again, the relay is off, the same as others. 3. Inter lock/Latching: Press remote button A, the relay A is on, B is off; press button B, the replay B is on, A is off.
PAGE 3
Caution: Any changes or modiﬁcations to this device not explicitly approved by manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.