STVG569BT
ENGLISH WARNINGS Warnings: ! This CD player employs a laser light beam. Only a qualified service person should remove the cover or attempt to service this device, due to possible eye injury. ! The use of controls, adjustments, or procedures other than those specified herein might result in hazardous radiation exposure. ! The apparatus shall be used in an open area. CAUTION This compact disc player is classified as a CLASS 1 LASER product. The CLASS 1 LASER PRODUCT label is located on the rear panel.
NOTE: This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set out in the Radio Interference Regulations of Industry Canada. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
/PAIR CDG/ BT PAIR (STOP)/PAIR
20. MIC 2 Jack 21. MIC 1 Jack 22. LINE IN Jack 23. DC Jack (DC 5.8V) 24. AUX OUTJack (L) 25. AUX OUTJack (R) 26.
5.
AUDIO OUTPUT AUDIO OUTPUT AUDIO INPUT AUDIO INPUT
ENGLISH CD OR CD+G OPERATION This unit is designed to play CDs and CD+Gs bearing the identification logo respectively. If the disc does not conform to the standard, it may not play properly. TURNING POWER ON/OFF ! To turn on the unit, press the ON/OFF button, the ON/OFF LED Indicator will light up. ! To turn it off, press the ON/OFF button again, the ON/OFF LED Indicator will turn off.
PROGRAM ! ! ! ! ! ! Use this button to program and play back songs in a preselected order. Step 1: Programming should be done in the stop mode only. Press the PROGRAM button, PROG SET 00 :XX Here " XX " stands for the total number of tracks, and it is blinking on the display. Step 2: Press the SKIP buttons ( - SKIP ) to select a desired track. Step 3: Press PROGRAM button to confirm entry. You can repeat the same steps up to a maximum of 24 tracks.
ENGLISH LINE IN OPERATION Your Singing Machine is designed to connect your favorite Digital Music device (e.g. iPod/MP3 player, etc.) You can connect your device by using an appropriate cable ( 3.5mm audio cable not included). LINE IN function can always be switched ON once the audio cable is plugged. Note: Monitor will be turned off when the audio cable is plugged. YOUR DIGITAL PLAYER OR MP3 PLAYER MASTER VOLUME Rotate to the MASTER VOLUME control to obtain the desired sound level.
If you have followed the instructions and are having difficulty operating the unit, locate the PROBLEM in the left column below. Check the corresponding POSSIBLE CAUSE column to locate and remedy the problem. PROBLEM No power when POWER is on. POSSIBLE CAUSE SOLUTION No power plug connection at Insert the power plug into the AC outlet. the AC outlet. No power when plugged The AC outlet may not have Check the outlet with a working power. lamp or other electrical appliance. in.
The Bluetooth device can not be paired Bluetooth on your device not activated Activate the Bluetooth on your device Bluetooth function is cut off Press the (stop) /PAIR button to restart Bluetooth pairing mode
ENGLISH 3.5 3 4 MONITOR SECTION LINE IN SECTION 5.5” BLACK AND WHITE MONITOR NTSC SYSTEM 220 LINE RESOLUTION 3.5mm stereo headphone jack DC 5.8V DIMENSIONS (W x D x H) 2A 9.1 x 8.8 x 13.6 inches / 23.1 x 22.4 x 34.5 cm 7.9 lbs / 3.