0.
CONTENTS Important Safety Information..........................................................................................3-8 General Operations.......................................................................................................9 Remote Control Operation.......................................................................................10-11 Bluetooth Operation........................................................................................................11 About Discs....
IMPORTANT SAFETY INSTRUCTIONS The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the product`s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
IMPORTANT SAFETY INSTRUCTIONS FCC NOTICE: WARNING This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not Installed and used in accordance with the instructions, may cause harmful interference to radio communications.
IMPORTANT SAFETY INSTRUCTIONS 7 ) Do not block any ventilation openings. Install in accordance with the manufacturer's instructions. Slots and openings in the cabinet and in the back or bottom are provided for ventilation, to ensure reliable operation of the product and to protect it from overheating. These openings must not be blocked or covered. The openings should never be blocked by placing the product on a bed, sofa, rug or other similar surface.
IMPORTANT SAFETY INSTRUCTIONS 16 ) Power lines An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.
IMPORTANT SAFETY INSTRUCTIONS f ) When the product exhibits a distinct change in performance-this indicates a need for service. NOTES ON HANDLING: ● When shipping the unit, always use the original shipping carton and packing materials. For maximum protection, repack the unit as it was originally packed at the factory. ● Do not use volatile liquids, such as insect spray, near the unit. Do not leave rubber or plastic products in contact with the unit for a long time. They will leave marks on the finish.
IMPORTANT SAFETY INSTRUCTIONS WARNING: NOTES ON MOISTURE CONDENSATION: Moisture condensation damages the DVD player. Please read the following carefully. ● Moisture condensation occurs, for example, when you pour a cold drink into a glass on a warm day. Drops of water form on the outside of the glass. In the same way, moisture may condense on the optical pick-up lens inside this unit, one of the most crucial internal parts of the DVD player.
GENERAL OPERATIONS 1. Lift up the panel and turn to desired angle. Slide the Power ON/OFF switch to "ON" position to power on the unit, the Blue Indicator on front of the player will light. 2. Slide the OPEN switch to left to open the disc door. Place the disc on the center spindle with label side facing up. Close the disc door and the player will start playback automatically. 3. During playback: ~ Press the or buttons repeatedly to fast search for a specific section forward or backward.
REMOTE CONTROL OPERATIONS LCD ON/OFF: Press to turn on or off the LCD display. POWER: Press to turn to standby mode, press again to turn on. VOLUME +/–: Press to increase or decrease volume. MUTE: Press to turn off the sound, press again to resume. SOURCE: Press to switch to AV IN mode, press again to resume normal mode. OSD: (On Screen Display) During playback, press the OSD button repeatedly to read the information of playback status.
REMOTE CONTROL OPERATIONS ~ Press the GOTO button the third time to display the time selection under Chapter. Using the Direction and Numeric buttons to enter the desired time. The unit will start play the movie from the selected time automatically. GOTO ( CD ) ~ Press the GOTO button once, using the Numeric and OK buttons to set the desired playback time of disc. ~ Press the GOTO button twice, using the Numeric and OK buttons to set the desired playback time of track.
ABOUT DISCS The region number for this DVD Player is: 1 See the following page for information regarding region numbers. PLAYABLE DISCS: The following discs can be played back on this DVD player: DISC TYPES: DVD Data on most DVDs is divided into sections called titles and then into subsections called chapters, each of which is given a title or chapter number. Some features of this DVD player will not operate with some DVD discs as they are preset.
LOCATION OF CONTROLS SOURCE DVD USB/SD VOL- VOL+ 1 2 3 5 4 5 6 4 7 8 PAIR SETUP 9 10 OPEN 11 1. SOURCE: Press to switch to AV IN mode, press again to resume normal mode. 2. DVD/USB/SD: When USB device and/or SD Card was inserted, press repeatedly to select the playback source as desired. 3. VOL(volume) - : Press to decrease the volume level. VOL(volume) + : Press to increase the volume level. 4. In disc playback mode, press repeatedly to skip to previous/next chapters/ tracks as desired.
LOCATION OF CONTROLS Right Side View: USB 12 AV-OUT CARD 13 14 12. USB port 13. Card slot (for SD/MMC card) 14. Earphone jack 15. AV OUT jack 15 AV-IN 16 OFF ON 17 DC IN 18 16. AV IN jack 17. Power ON/OFF switch 18. DC IN jack Front Side View: 19 20 21 19. Charging indicator 20. Remote sensor 14 21.
REMOTE CONTROL 15. SLOW button 16. LCD ON/OFF button 17. Numeric buttons 18. SETUP button 19. Skip Previous button 20. Fast Backward button 21. OSD (On Screen Display button 22. SUBTITLE button 23. ANGLE button 24. PROG ( Program ) button 25. OK button 26. STEP button 27. ZOOM button 28. A-B Repeat button 1. POWER button 2. VOLUME +/– buttons 3. MUTE button 4. SOURCE button 5. Direction buttons 6. Skip Next button 7. Fast Forward button 8. ( Play/Pause ) button 9. DVD/USB/SD button 10.
BATTERY INSTALLATION BATTERY INSTALLATIONS (Remote Control) 1. Press the tabs on the battery door and lift it off. 2. Install two (2) x AAA size batteries into the battery compartment as the figure on right and the polarity markings inside battery compartment. 3. Replace the battery door. BATTERY PRECAUTIONS Follow these precautions when using batteries in this device: 1. Use only the size and type of batteries specified. 2.
POWER SOURCE Charging by AC/DC Adapter: 1. Connect the small plug of AC/DC Adapter to the DC IN Jack on the right of unit. 2. Connect the AC/DC Adapter to the wall outlet with AC 100-240V~; 50/60Hz. 3. During charging in power on mode, the Charge Indicator will light up red. When finished, it will turn Yellow. Note: Your battery will last longer if you follow these simple guides for caring for and storing it. A. Recharge and store the device within the temperature range of 5°C~35°C (40°F~95°F). B.
SWIVEL PANEL The viewing angle of the swivel panel can be adjusted as below as desired: 18
USB OR CARD PLAYBACK 1. Insert the USB Device or SD/MMC memory card into the USB port/card slot as the figure below. 2. In power ON mode, press the DVD/USB/SD button, the "DISC, CARD, USB" selection window will pop up on the screen. Using the Direction buttons to select and highlight the desired source then press the OK button to confirm. 3. During playback: or button repeatedly to skip tracks. ~ Press the ~ Press the or button repeatedly to select and set the fast searching speed.
OTHER WAY TO PLAY Connecting to a TV or Video Player (such like DVD; VCR; DVR Players ... ) with AV connection cable. NOTE: ● The default setting of the unit is AV OUT, if connect to external video player (such like DVD; VCR; DVR Players ... ), press the SOURCE button to set to AV IN mode ("AV IN" will appear on the screen). Press again to turn back to resume normal mode. ● Using the supplied earphone to listen privately.
SYSTEM SETUP Setting Menus: Press the SETUP button, the setting menu will appear on the screen as below. Using the Direction , , ▲ , ▼ buttons to select and highlight the function you need to set or reset. Press the OK button to enter or confirm the selection. After setting, press the SETUP button to save and exit. In General Setup Page: 1. If TV Shape is selected, using the Direction and OK buttons to set the aspect ratio to match connected TV. 2.
CARE AND MAINTENANCE Caring for Disc Treat the disc carefully. Handle the disc only by its edges. Never allow your fingers to contact with the shin, unprinted side of the disc. ● Do not attach adhesive tape, stickers, etc. to the disc label. ● Clean the disc periodically with a soft, lint-free, dry cloth. Never use detergents or abrasive cleaners to clean the disc. If necessary, use a CD cleaning kit. ● If a disc skips or gets stuck on a section of the disc, it is probably dirty or damaged (scratched).
SPECIFICATION Power Source: Built-in DC 12V 1A Lithium-ion rechargeable battery, recharge by: DC 7.