BLUETOOTH SPERAKER Model:PBT510
Safety Instructions -The lighting flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. -The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.
Product Overview Control Panel 1. Volume up button 2. Play/Pause/Standby button 3. Next button 4. Volume button 5. Built-in microphone 6. Previous button Jack Panel 7. Aux Jack 8.
Charge Battery The device is operated via the integrated lithium battery. Charge the battery as follows: 1.Plug the micro B USB plug of the charging cable into the jack of the device. Connect the USB plug to a powered-on computer. The indicator lights up red and the battery begin to charge. 2.If the battery is completely charged, the indicator red light turns off. 3.Remove the charging cable from the Speaker and PC.
3. Chose the Bluetooth menu in your player and register the device in your player. For For this, refer to the operation manual of your player. The Device “PBT510WG” Will show in your player as a selection. 4. If the playback device was recognized,The Bluetooth indicator will blink slowly. After successful registration, the Bluetooth indicator will stop flashing. Note: -Depending on the device manufacturer, you need to perform the registration (PAIRING) again to connect the devices.
Accepting / Ending/Refusing call ·Press the Phone button to accept an incoming call. ·To end the call, press the Phone button again. ·Hold the Phone button to refuse an incoming call Troubleshooting Symptoms Cannot switch the Speaker Possible cause Solution Battery exhausted Charge the battery. No audio signal during Volume of the external audio Increase the volume of the playback through AUX. source is too low. external audio device. Volume of the device too low Increase the volume with + on.
Technical Specifications Audio output ...........................................................................................................................1W Power supply:...................................................................................................................DC 5 V Battery:..............................................................................................3.7V,400mAh Lithium-lons Operating time:.......................................................................
FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.