User's Manual

ManualsBrandsShenzhen Jixin intelligence ManualsElectronics2.4G WIFI/BT module

BL-01S WIFI+BLE module

BL-01S User manual

Version V1.1

Summary of content (14 pages)

PAGE 2
BL-01S WIFI+BLE module This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) This device and its antenna(s) must not be co‐located with any other transmitters except in accordance with FCC multi‐transmitter product procedures. Referring to the multi‐transmitter policy, multiple‐transmitter(s) and module(s) can be operated simultaneously without C2P.
PAGE 3
BL-01S WIFI+BLE module 1. Product Overview BL-01S is a wireless module based on WiFi+BLE single-chip SoC as the main control. It meets low-power, high-performance, low-cost IOT application scenarios. The module's core processor BL602C integrates 2.4G Wi-Fi (802.11 b/g/n) and BLE 5.0 wireless subsystem. Its microcontroller subsystem includes a high-performance and low-power 32-bit RISC-V CPU, high-speed cache and FLASH memory.
PAGE 6
BL-01S WIFI+BLE module 1.2 Features 1.2.1 Wireless ◼ IEEE 802.11b/g/n, 1x1 SISO 2.4GHz ◼ Bluetooth® BLE 5.
PAGE 7
BL-01S WIFI+BLE module ◼ DFS (Dynamic Frequency Scaling) from 1MHz to 192MHz ◼ JTAG development support ◼ XIP QSPI Flash has hardware encryption support 1.2.3 Memory ◼ 276KB RAM ◼ 128KB ROM ◼ 1Kb eFuse ◼ Embedded 2M Byte flash 1.2.4 Security Mechanism ◼ QSPI Flash Instant AES Decryption (OTFAD)-AES-128, CTR mode ◼ Support AES 128/192/256 bit encryption engine ◼ Support SHA-1/224/256 ◼ Real random number generator (TRNG) Public Key Accelerator (PKA) Copyright © 2020 ShenzhenJiXinInteligence Co.
PAGE 8
BL-01S WIFI+BLE module 1.3 Key parameter Table 1.1 Description of the main parameters Module model BL-01S Mounting DIP-8 Size 24.7*14.5*11.5(±0.2)mm Cert. FCC、CE Flash Chip built-in 2MB Interface UART/GPIO/ADC /PWM/ I2C IO 口 5 Number of GPIO 9600/19200/38400/115200/921600 bps , Up to 5Mbps Freq. 2400 ~2483.5MHz Antenna Onboard PCB antenna Security WPS/WEP/WPA/WPA2 Personal/WPA2 Enterprise/WPA3 Power Supply DC 3.0V ~ 3.
PAGE 9
BL-01S WIFI+BLE module 2. Pin definition BL-01S module has 8 pins in total, as shown in Figure 2.1. Peripherals include 5 GPIOs, 2 UARTs, 1 I2C master/slave, 4 PWM channels, and 1 12-bit general-purpose ADC. Each GPIO can be used as a generalpurpose input and output function. Table 2.2 is the interface definition. 2.1 Figure 2.1 BL-01S Pin diagram Table 2.
PAGE 10
BL-01S WIFI+BLE module 3 IO3 GPIO3; I2C_SDA; UART1_RX; PWM_CH3 4 IO4 GPIO4; I2C_SCL; UART1_TX; PWM_CH4; ADC_CH1 5 IO8 GPIO8; I2C_SCL; PWM_CH3; IO8 should be pulled high when downloading, and low when running (IO8 inside the module has been pulled low) 6 RST Reset 7 RX GPIO7; UART0_RX; I2C_SDA; PWM_CH2;(Only this UART0 can be used to burn firmware) 8 VCC Power supply 3.3V 3. Electrical parameters 3.1 Electrical characteristics parameter test condition min Typ.
PAGE 11
BL-01S WIFI+BLE module Supply volt. VCC 3.0 3.3 3.6 V VIL VCC_IO=3.3V -0.3 - 1.32 V VIH VCC_IO=3.3V 2.06 - 3.6 V VCC_IO=3.3V, -0.3 - 0.4 V 2.9 - 3.4 V - - 12 mA I/O VOL VOH IMAX |IOL|=7.5~50 mA VCC_IO=3.3V, |IOL|=7.5~50 mA - 3.2 Wi-Fi RF characteristic Description Frequency Min 2400 S11 Typ. - Max 2483.5 <-10 Unit MHz dB Transmit Power CCK, 1 Mbps - 18.4 - dBm CCK, 11 Mbps - 18.1 - dBm 6 Mbps OFDM - 16.6 - dBm 54Mbps OFDM - 15.
PAGE 12
BL-01S WIFI+BLE module HT20, MCS7 - 14.5 - dBm CCK, 1 Mbps - -21.8 - dB CCK, 11 Mbps - -21.2 - dB 6 Mbps OFDM - -30.3 - dB 54Mbps OFDM - -32 - dB HT20, MCS0 - -30.2 - dB HT20, MCS7 - -31 - dB EVM Receiver Sensitivity CCK, 1 Mbps - -97 - dBm CCK, 11 Mbps - -92 - dBm 6 Mbps OFDM - -92 - dBm 54 Mbps OFDM - -76 - dBm HT20, MCS0 - -92 - dBm HT20, MCS7 - -74 - dBm Copyright © 2020 ShenzhenJiXinInteligence Co.
PAGE 13
BL-01S WIFI+BLE module 3.3 Power dissipation BL602, 25℃, VCC=3.3V Work mode Test condition 11b Min. - Typ. 35 Max. - 11g - 39 - 11n - 39 - Duty 50% 190 - Duty 99% Duty 50% 310 145 - Duty 99% Duty 50% 230 130 - Duty 99% 215 - Run Freq@ 192MHz 22 - MCU Standby Freq@<10MHz 2 - Sleep PDS7 Fast recover 12 - Hibernate HBN RTC or GPIO wakeup 0.5 - - 0.1 - RX 11b - 11Mbps @21dBm TX 11g - 54Mbps @18dBm 11n - MCS7 @17dBm Shut-down - unit mA uA 4.
PAGE 14
BL-01S WIFI+BLE module 5. Application circuit 6. Contact Us Address：A505 Room,Business Building,Suojia Science Park,Xixiang,Baoan District,Shenzhen Telephone：0755-23220940 Website：www.aimachip.com Copyright © 2020 ShenzhenJiXinInteligence Co.