Wall Mounting Wall Mounting You may choose to put the BASE UNIT of your cordless telephone on a wall. 1. With the back of the BASE UNIT facing up, connect the SHORT TELEPHONE LINE CORD to the TELEPHONE LINE CONNECTION JACK. 2. Insert the free and of the SHORT TELEPHONE LINE CORD through the hole of the MOUNTING BRACKET. 3. Insert the hooks of the MOUNTING BRACKET into the matching slots on the back of the BASE UNIT (as shown below). Then slide the MOUNTING BRACKET until it locks into place.
Receiving Calls Receiving Calls with the HANDSET on the BASE UNIT 1. When the phone rings, fit the HANDSET. TS The IN USE LED indicator will light up. | ETN i 2 NOTE: The HANDSET RINGER Switch must the “ON” position for ringer to TCD {=D operate, Stan your conversation. 3. To end your conversation, either press the (alk button or place the HANDSET on the BASE UNIT. If you place the HANDSET en the BASE UNIT charge cradle, you activate the AUTOMATIC STANDBY feature.
Storing Numbers Storing Numbers 1. Bs sure the BASE UNIT IN USE LED a Ares @ BRL Sontag indicator is off and the HANDSET is in i STANDBY mods (See Special Features | Section) \ |e foi) 2. Press the (memo) button. 3. Dial the number you want to store. a, Press the (Te ma) button again Dishevel TELEPHONE KEYPAD ( &0)~ 8) button where you want to store that number. You will hear one confirmation “beep.” 6.
Security Security System Your cordless telephone uses & digital coding security system to prevent unauthorized uss of your elephantine line by another nearby cordless telephone. The system has its own identifying signal created by microcomputers in both the BASE UNIT and HANDSET Security Code ! } “This telephone has an internal security code with $6,536 possible combinations.
Changing the BATTERY PACK The BATTERY PACK provides power for the HANDSET of your cordless telephone, To Replace the BATTERY PACK: 1. Remove the HANDSET BATTERY COMPARTMENT COVER by siding t down. 2 Pull out the BATTERY PACK PLUG and remove the BATTERY PACK. 3. Plug the new BATTERY PACK info the BATTERY CONNECTOR. a Side the HANDSET BATTERY COMPARTMENT COVER finny into place In lls closed position. 5. Before use. charge the new BATTERY PACK for 12 hours.
Technical Information ~ This cordless telephone uses radio frequencies to allow mobility. There are certain difficulties in using radio frequencies with a cordless telephone. ‘While these are normal, the following could affect the operation of your system. Noise ] Electrical pulse noise is present in Most homes at one time OF another.
Federal Communications Commission Requirements (continued) NOTE: Tis equipment has bean tested and found to comply with the limits for & lass B digital device, pursuant to Part 15 of the FCC Rules. “These limits are designed to provide reasonable protection against harmful interference in a residential installation, This equipment generates, USES and can radiate radio {frequency energy and, it not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Warranty What to Do for Warranty Service During the first thirty (30) days, a defective product is eligible for over-the-counter overhangs at the retailer from whom it was purchased. After thirty (30) days, thee Cognitive product should be returned to the authorized service center. Please allow 2.3 weeks for the return of your telephone product. The shipping address of ihe authorized service center is: U.S. Electronics CONSUMER CENTER CIO Southern Bonded Warehouse 1491 Mt. Zion Rd.
IMPORTANT in order ta get maximum life from the HANDSET BATTERY PACK, he sure to charge the HANDSET for 12 hours before initial use. IMPORTANT Placing your BASE UNIT near appliances such as televisions, refrigerators, readies, or microwave ovens may cause interference. This page serves as a template for attachment of screws to the wal when TTA dA ba mounting this telephone on the wall. Area button to change the operating 1. Cutout this page. channel.