Installation Instructions

Manual
Areas of application:
Remote control switches,alarm systems, , remote control door locks, remote control electric
shutter doors and Windows, water pump control, industrial control products, etc.;
technical parameters:
Working voltage: DC6V
Working frequency: 433.92 MHz
Standby current: 0MA
Working current: > 20MA
Encoding Type: fixed code (2264) and learning code (EV1527)
Transmission distance: > 30 m (open area sensitivity more than 103 dBm)
Output power: 30 m (0 DBM);
Transfer rate: < 10 KBPS
Modulation mode: ASK (amplitude modulation)
Working temperature: - 10 ℃ ~ + 70 ℃
Size:30 * 60 * 12 mm
* Tips: 1. This series of remote wireless remote control with 1/2/3/4key optional;
2.With the power switch, remote control can turn off the power save electricity when not
in use.
Federal Communications Commission Notice
This device complies with part 15 of the FCC Rules. Operation is subject to the following two co
nditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance co
uld void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable p
rotection against harmful interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in accordance with the inst
ructions, may cause harmful interference to radio communications. However, there is no guarante
e that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment of
f and on, the user is encouraged to try to correct the interference by one or more of the followin
g measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is con
nected.
-Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in p
ortable exposure condition without restriction.