Quick User Guide HA001
Notice: The batteries come with the controller are just for temporary use purpose and won’t last long.
Step1 Unlock the battery storage cover at the back of the controller, take out the wireless USB receiver, and plug it into the USB slot of Mini PC or other smart devices such as the PC or tablet. Open the battery cover, right into the battery, Smart remote and receiver connections use Step2 Turn the power switch of the controller to the “ON” position. The red led light flashes, indicating the controller go active.
Step3 As below illustrates the working zone of touch pannel, as well as the operation instructions. Mouse Control and Tap Use one finger to move on the touch panel, to control the movement of the cursor on the displayed screen accordingly. Move the cursor to the targeted object on the screen, single tap on the touch panel to make the execution.
Gesture Control: Scroll / Drag / Stroke Such controls must be achieved with coordination of holding the “Mouse Left” key. By holding the “Mouse Left” key, the single finger movement on the touch area does not perform the cursor control any more, corresponding gesture controls with respect to different applications.
Troubleshooting Troubles If your Smart remote does not respond Pointer doesn’t move smoothly Zoom in/out function doesn’t work Causes Analysis Solutions The remote might go into standby mode Press any button on the remote to wake it up. The remote stop working Restart the remote The 2.4G signal lost Repair the 2.4G USB dongle with the controller (follow the instruction on page one). Low battery Change the batteries The 2.4G signal is interfered Move the usb 2.4G dongle away from Wi-Fi The 2.
FCC Certification Requirements Caution: Any changes or modifications in construction of this device which are not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
