User's Manual

ManualsBrandsSHENZHEN HUOER TECHNOLOGY ManualsAudio EquipmentT59 Bluetooth headset

真无线立体声耳机

用户手册

User Manual for True Wireless Stereophone

产品描述

Product description

蓝牙版本：5.0

Bluetooth version: Version 5.0

工作温度：-5℃到 40℃

Operating temperature: -5℃~40℃

耳机电池容量：50mA/h

Battery capacity: 50mA/h

充电时间：约 60 分钟

Charging time: Approx. 60 minutes

音乐时间：约 5 小时（中等音量）

Music time: Approx. 8 hours (moderate volume)

芯片类型：AT3015

Chip type: AT3015

音频解码：AAC, SBC

Audio decoding: AAC, SBC

喇叭类型：13MM 全频复合膜喇叭

Speaker type: 13MM full-frequency composite film speaker

频响范围：20Hz-20KHz

Frequency response range: 20Hz-20KHz

关机待机时间：90 天

Power off Standby time: 90 days

连接距离：12 米

Connection distance: 12 meters

Summary of content (5 pages)

PAGE 1
真无线立体声耳机用户手册 User Manual for True Wireless Stereophone 产品描述 Product description 蓝牙版本：5.0 Bluetooth version: Version 5.0 工作温度：-5℃到 40℃ Operating temperature: -5℃~40℃ 耳机电池容量：50mA/h Battery capacity: 50mA/h 充电时间：约 60 分钟 Charging time: Approx. 60 minutes 音乐时间：约 5 小时（中等音量） Music time: Approx.
PAGE 2
支持机型：可与支持 AAC/HFP/HSP/AVRCP/A2DP 协议的蓝牙设备配合使用，如手机、电脑等等进行通话、听歌等功能 Model supported: It can be used in combination with bluetooth devices supporting AAC/HFP/HSP/AVRCP/A2DP protocol, such as mobile phones and computers to make a call or listen to music, etc. 移动充电盒 Mobile battery case 输入电流：5V\500mA Input current: 5V\500mA 输出电流：5V\50mA/h Output current: 5V\50mA/h 充电盒电池容量：600mA/h Capacity of the battery in the battery case: 600mA/h 充电次数：约 4.5 次 Charge cycles: About 4 .
PAGE 3
开机： Power on 1：打开充电仓，取出耳机，耳机自动开机。2：手动长触摸区域 3 秒开机 1: Open the charging chamber, take out the earphone, and the earphone will turn on automatically.
PAGE 4
Please charge fully the earphone every time when you use it and sufficient battery power shall be kept for the device or cellphone to be paired, turn on the earphone to bring it into the pairing mode (the White LED indicator light flashes) and keep it as close as possible to the cellphone to be connected.
PAGE 5
FCC Warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.