& Ages 14+ Pusan READ THE INSTRUCTION MANUAL CAREFULLY THE HUBS AN X4 FPV BRUSH LESS ITEM NO.
Hubs an FPV X4 Brush less HE asm Please read the instruction manual carefully! IMPORTANT SAFETY NOTES OPERATION: Ba extremely careful and responsible when using the FPV X4 . Small electronic components can be damaged by crashing or by dropping the X4 in water. To avoid further damage to the unit, people, or property, damaged spare parts should be replaced in time. Flight: = Take responsibility for your safety and the safety of others when you fly the X4 t Do not fly the X4 In crowded places.
LIP BATTERY SAFETY NOTES If the X4 doesn't in use for a week or more, please store the battery approximately 50% charged to maintain battery performance and battery life. SAFETY ADVISORY NOTICE Lithium-Polymer (Li Po) Batteries Lip batteries are different from conventional batteries In that their chemical contents are encased in a relatively lightweight foil packaging.
INDEX IMPORTANT SAFETY NOTES SYMBOL EXPLANATION USAGE ADVICE. Li Pd BATTERY SAFETY NOTES INDEX INTRODUCTION 1 ITEMS INCLUDED IN THE BOX QUAD COPTER 21 Flight Control System Introduction 22 Quad Copter Motor Led Indicator 3 QUAD COPTER BATTERY 3.1 Introduction 3.2 Install the Battery 3.3 Charging 4. PROPELLER 4.1 Introduction 4.2 Assembly 4.3 Disassembly 5 Transmitter 5.1 Input key function 5.2 install the TX battery 5.3 Transmitter calibration 54 Frequency delectable 5 GHz 6. START LOFTY 6.
INTRODUCTION Thank you for buying the HUBS AN quad copter. The X4 quad copter is designed as an easy-to-use, full-featured RC model, capable of hovering, fast forward and aerobatic flight maneuvers. Please read the manual carefully and follow all the Instructions. Be sure to retain the manual for future reference, routine maintenance and tuning. 8 FPV: from the quad's view. First Parson View Function enables you to experience every live moment of the flight A.
2 QUAD COPTER Propeller B [2] Propeller A [3] Motor [4] Motor LED Indicator [5] Upper body shell [6] Lower body shell [7] 1080P HD Camera [8] Battery compartment [9] TF card plug 2.1 FLIGHT CONTROL SYSTEM INTRODUCTION The quad copter’s flight control system with a built-in GPS and compass that is used to control the quad copter’s functions such as ascend and descend, pitch and roll.
3. QUAD COPTER BATTERY 3.1 INTRODUCTION The quad copter battery is a rechargeable lip battery with 2700mAh capacity and 7 4 voltage. The battery should only be charged with the HUBS AN charger. 3.2 INSTALL THE BATTERY Push the battery into the battery compartment correctly and connect the battery plugs in correct polarity. Close the battery compartment cover. 3.3 CHARGING Connect the battery to the balance charger and wall charger.
4 PROPELLER 4.1 INTRODUCTION The quad copter uses the propellers which are marked by A and B. Damaged propellers should be replaced in time to maintain the good performance Diagram installation Post ion Symbol explanation 4 LOCK: In this direction, tighten the propeller onto the motor shaft & UNLOCK: In this direction, remove the propeller from the motor shaft 4.2 ASSEMBLY Assemble the propellers on the motor threads that marked the same letter and lock them according to the instruction way. 4.
5 TRANSMITTER Fy LCD f 12 GPS SW 13TH SW 8 Photo. oh id 9 Video 4 Elevator Trim 5 6 Throttle Trim (2) Elevator/Ruddar Stick 8 {1) Throttle /Baronial Stick . 7 Power SW 5 Rudder Trim: 3 Aligner Tim Ls {MODE 1) 10 Video glasses socket 11 TF card plug No function 14 USB Plug LoD 12 GPS SW-13 RTH SW 8 Photo. 5 5 8 Video 6 Throttle Trim 5 4 Elevator Trim 1 Throttle /Rudder Stick @ 2 Elevator/Aileron Stick .
5.1 INPUT KEY FUNCTION 8/N| Mode/ Control Function MODE 1 Push the stick forward or backward and the quad copter will 1 ascend or decant; Push the stick left or right and the quad copter Atherosclerotic Stick will fly left or right. MODE |Push the stick forward or backward and the quad copter wil fy 2) | Undervaluation Stick | forward or backward:Push the stick left or right and the quadruplicate will rotate in counter clockwise or in clockwise.
5.2 INSTALL THE TX BATTERY PUSH & PUSH Remove the cover Install 4 x AA batteries Replace cover according to the correct polarities « Do not mix old and new batteries Do not mix different types of batteries « Do not charge non-rechargeable hatter. 5.3 TRANSMITTER CALIBRATION Mode 2: Push both sticks to the upper left position and power on the transmitter simulatenously,rotate both sticks twice.
5.4 FREQUENCY DELECTABLE 5.8GHZ The transmitter wil automatically find the best frequency to ensure a quality live video transmission. In case any Interference, please re-elect the frequency from 5730MHZ to 5B845MHZ to get a better video transmission Pull the throttle stick to the west position and long press the Elevator stick to enter Into the MAIN MENU Interface. Push the Elevator stick up/down to select “5.8G Frequency”, push the stick right to enter Intel the * 5.
6.1 THE FLIGHT ENVIRONMENT (1) The flying area should be open and without tall buildings or other obstacles; the steel structure within building would interfere with the compass. (2) DO NOT fly in bad weather such as strong wind, heavy snow, rain or foggy day. (3) Esp away from barriers, peoples, power cables, trees, and other obstructions. {4) Do not fly near radio towers or airports.
START 7. START STOP THE MOTORS Start the motors Method : Pull the two sticks as the picture shows. Release them after the motors start. Stop the motors Method : Pull the sticks again, as seen in the picture, and release them fare the motors stop. Calibration eve @ Do not stop the motors during the flight to avoid any crash. Xj Push the sticks as slightly as you can. Release the sticks afar the motors start or stop. 8. BASIC FLIGHT ‘The operation mode for the transmitter Is Mode 1 or Mode 2.
Right rotation The Rudder sick controls the facing direction Push the stick left and the X4 wi rotate ‘counter-clockwise. Pugh the stick right snd the Xa wil motets clockwise ‘When the stick Is In center the X4 rotation ‘angle i zor and doyen' oral A herder push In ether direction wil cause the 4 1a rotate fester bh the corresponding direction The Elevator stick moves the Xé forward and backward Push the stick up the and the X4 wi fy forward Pull the stick down and the X4 and backward.
FCC INFORMATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. Tess limits are designed fo provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.