www.hubsan.com ® Ages 14+ Please read the instructions carefully before use.
www.hubsan.com www.hubsan.com CATALOG INCLUDED ACCESSORIES 02 EXPLODING VIEW 02 SAFETY NOTES 02 ASSEMBLY INSTRUCTIONS 04 CHARGING THE LI-PO BATTERY 06 2.4GHz & 5.8GHz TRANSMITTER 06 5.
www.hubsan.com www.hubsan.com Included Accessories H301S-17 H301S-18 H301S-19 H301S-20 Camera module 5.8GHz TX module Lipo battery Servo set Lipo battery Adapter Balance charger SD Card Manual Body stickers Exploding View 3.7G Servo GPS Brushless motor ESC H301S-21 H301S-22 H301S-23 H301S-24 Linkage wires LED light bars SD Card Body stickers 3.7G Servo Green LED light bar Lipo battery 5.8GHZ TX module Camera cap 1080 Camera module 3.7G Servo RX board Red LED light bar 2.
www.hubsan.com ! LiPo batteries are different from conventional batteries in that their chemical contents are encased in a relatively lightweight foil packaging. This has the advantage of significantly reducing their weight, but does make them more susceptible to damage if roughly or inappropriately handled.
www.hubsan.com www.hubsan.com Do not enter into the transmitter setting status during flight! The controller will not transmit a signal in the setting status. Carefully start the recording function key by just briefly clicking the “ENTER” key. Do not press the “ENTER” key more than 1 second or the controller will stop transmitting! Question 13 : The values on each channel showing on the LCD screen are not correct. 2.
www.hubsan.com www.hubsan.com The parameters of the stabilization system are factory preset, no need for initialization. Question 6: The LCD screen is not viewable outdoors with bright sunshine. Answer: Check the packaging inside the box, there is an anti-glare sticker, it will help you to reduce glare in full sunshine. Peel the protective membrane and put it onto the screen. Question 7: The battery life is too short and the battery will not charge.
www.hubsan.com www.hubsan.com H301S TROUBLESHOOTING 3. CHARGING THE LI-PO BATTERY Question 1:The Air Plane dives when switching on/off the autopilot button. The Air Plane is equipped with a LiPo battery: Answer: 3.1 7.4V 2 Cell 1300mAh x 1 unit Always check the rudder, aileron and elevator both on stabilization status and non-stabilization status if you would like to switch on/off autopilot mode during flight.
www.hubsan.com www.hubsan.com 8.2 Expert mode TRANSMITTER In expert mode, the sensitivity can be adjusted even further (up to 100) to give the user even more ability to manoeuver the Air Plane. Follow instructions below to switch this on/off. 9 Antenna 10 SA SB SC LCD 5.8GHz Antenna SD Hold the ENT key for 1 second to enter the settings menu. Move the arrow to “Expert mode” with the up/down keys. Press ENT to switch between Yes and No for turning the expert mode on or off.
www.hubsan.com www.hubsan.com 8. ADVANCE PERFORMANCE SET UP 4.2 Input Key Function S/N 8.1 Mode 1 and Mode 2 Reversing setup b a 1) Open the cover of transmitter by unscrewing the 4 screws as picture shows. a a b b Hold down ENT key for 1 Second to enter setting status. Press the ENT key to enter reverse setting status.
www.hubsan.com www.hubsan.com 7. VIDEO RECORDING 4.3 Battery mounting Notice: >Do not mix old and new batteries >Do not mix different types of batteries >Do not charge non-rechargeable battery. Note: Always turn OFF the Air Plane's power before inserting or removing the SD card. Always stop the video recording function and power off the battery firstly, and then you can take out the SD card. 7.1.
www.hubsan.com www.hubsan.com While if the GPS value shows NA, indicating the GPS is not connected or broken, need to check the connect wires and the GPS module. The plane can take off without GPS function, only in that way the Return to Home function is useless. 6.3 Launch the plane 5 5.8GHZ TECHNICAL TIPS Keep the FPV 5.8Ghz antenna pointing as straight down as you can to give you a clear video picture and to avoid interference. 6.3.
www.hubsan.com www.hubsan.com Hold down the ENTER key for 1 second to enter setting status, move the arrow to 5.8G FREQUENCE with up/down key, press the ENTER key again and select the frequency you need with up/down key, hold down the EXIT key for 2 seconds to confirm and exit. GPS 7 HUBSAN GPS 11.5V Set reverse + Set sensitive + Plane type Air plane Expert mode Yes Stick mode 2 5.
