® User Manual HT005 Repeater V1.0 www.hubsan.
Introduction HUBSAN HT005 is a wireless signal amplifier specially designed for Hubsan WIFI models. Using HT005 with X-Hubsan APP, can receive high-quality image signals and stable operations.
LED Indicator Descriptions: Status Indicator: LED will remain red during startup and turn green after startup is completed. Battery Level Indicator: When charging, the LED indicators will blink in blue and remain solid when fully charged. Each LED indicator represents 25% of battery level. Battery HT005 has a built-in Li-Po battery. The battery has a capacity of 2600mAh with functions of overcharge protection,over discharge protection and low voltage protection. Battery Specification Type Voltage LiPo 3.
Charging the Battery Connect the repeater to a Micro USB charger. battery level indicators will blink when charging, and remain solid after charged completely. The power source can be a 5V adapter or a PC. If the charge current is 1A,the charging time will be approximately 3 hours.A fully charged battery will last for 2 hours before it needs to be charged again. Adapter is not included in the package and the maximum charging current is 2.6A.
1.Power on the Repeater; 2.Search for WI-FI on devices: For iPhone or iPad, please select【Settings】 >Wi-Fi; For Android system,please select【Settings】 >WLAN> WI-FI. 3.Click HUBSAN_HT005_XXXXXX, and password is 12345678. The password cannot be changed by user. 4. After connection completed, open X-Hubsan APP, choose the quad model (for example Hubsan H507A) to enter into the user interface. 5. Tap the Settings in APP, choose “Repeater”, click “Connection Settings” to link the relay with quad.
FCC INFORMATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CAUTION RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE, DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS Environmentally friendly disposal Old electrical appliances must not be disposed of together with the residual waste, but have to be disposed of separately.
7