Wiring Diagram

RGB Fountain / Pond Light
LPL-RGB9WR
Specications Control Color/Mode By Switch
Control color/mode selection by quickly switching
the light o󰀨 and on. Each time this happens, the
light will change to the next color/mode cycling
through the below list.
Red
Green
Blue
Purple
Cyan
Yellow
RGB (White)
Red-Green-Blue Jump
Colorful Jump
Red-Green-Blue Fade
Colorful Fade
E󰀨ects Cycle
Remote Control (LPL-RMT)
Brt+ : increase brightness
Brt- : decrease brightness
S+ : increase speed
S- : decrease speed
ON : on
OFF: o󰀨
R: red
B: blue
Pu: purple
Cy: cyan
Ye: yellow
W: RGB white
RGB Jump: red-green-blue jump
CLF Jump: colorful jump
RGB Fade: red-green-blue fade
CLF Fade: colorful fade
EFT Cycle: e󰀨ects cycle
Memory Function
The light will remain on the same color
or mode after power cycling.
Reset/Sync Function
Switch power o󰀨 for at least 30 seconds,
then switch on/o󰀨 3 times quickly. This
will reset the color/mode to default, so all
connected LPL-RGB9WR lights will be
synchronized.
• Product should be installed and serviced in
accordance with applicable national, state,
and local building and electrical codes.
• To reduce the risk of electric shock, ensure
that the main power source and circuit
breakers are switched o󰀨 before performing
any installation or wiring procedures.
• Avoid looking directly into lamp when
illuminated.
• Ensure all mounts are securely attached and
will support the weight of the xture. Failure to
properly support xture may result in damage
or injury, for which the manufacturer does not
assume responsibility.
• Light must be submerged when powered on
to avoid overheating. Submersion depth
should be equal to or less than 49.2 ft (15 m)
to avoid water intrusion.
• Avoid direct contact with chlorine or
substances that contain chlorine.
• Appropriate waterproof connectors are
required in order to maintain waterproof rating.
There is no maintenance required for this light–
it is designed to be used only once, meaning
that replacement is not necessary if it becomes
defective (repairing not possible). Before any
servicing, ensure there is NO voltage supplied
to the lamp.
*maximum depth of 49.2 ft (15 m)
The manufacturer will warranty this LED
underwater light bulb against defects
in materials and workmanship for a period
of 3 years from the purchase date.
This warranty does not cover the xture
becoming damaged due to misuse, accidental
damage, improper handling and/or installation
and specically excludes liability for direct,
incidental or consequential damages, or
water coming into the housing.
Safety and Notes Maintenance
Warranty
Wiring Diagram
LED
12 VAC / VDC
Power Supply
or Transformer
Environmental Specications
Input Voltage 12 VAC/ 12 VDC
Operating Temperature -13°–122° F (-25°–50° C)
IP Rating IP68*
Max. Submersion Depth 49.2 ft (15 m)