Wireless Dimmable Controller User Guide HLC610-Z
HLC610-Z is a kind of ZigBee 0-10V controllers that works with 010V LED dimmable driver. 1 Environment and Electrical parameters Parameters HLC610-Z Ac In Ac Out 100-277Vac 100-277Vac to constant current power supply Dim Out 0-10V RJ12 Motion Sensor & Daylight sensor module Max Current of 0-10V 20mA Max Current of Relay 10A Wireless Frequency 2.
ACL In ACN In 0-10V/PWM+ HLC610-Z Controller GND ACN Out ACL Out 0-10V/PWM Driver LED+ LED- Highbay 3 Installation 3.1. Install App into smart phone or tablet device . 3.2. iOS: search and install “iLightsIn” from App Store or scan the iOS QR code. 3.3. Android: search and install “iLightsIn” from Google Play or scan the android QR code.
iLightsIn App User Guide 4.1. WiFi settings Power on the gateway. Please select the WLAN iLightsInxxxxxx on mobile settings menu. The xxxxxx is the mac address at the back of gateway. Connect the WiFi AP, and open iLightsIn App (Picture1). 4.2. Enter application Help menu will pop up first time you open the App. When finishing reading the instruction, you are directed to the Settings menu. User can start to add device or connect the gateway to a router from Settings. 4.3.
4.4. Area Users can create different areas and put relevant devices in. Click one area, enter the sub menu and all different devices are listed there. User can control each device in this area (Picture4). - Move the slider to change color or brightness. - Click to enter Timer or Delay menu. Under this menu, user can set timers or delays and different status while timeout (Picture5). 4.5. Binding settings User can bind touch switches or remote controls to lights in this menu (Picture6).
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.