Installation Instructions
HST -300 Module for Bluetooth 5 LE
The HST-300 is a line of powerful, highly flexible, ultra-low power Bluetooth Smart modules
based on the nRF52832 SoC from Nordic Semiconductor. With an ARM® Cortex™ M4F CPU,
embedded 2.4GHz transceiver, and integrated antenna, they provide a complete RF
solution with no additional RF design, allowing faster time to market. Providing full use of
the nRF52832’s capabilities and peripherals, the HST-300 can power the most demanding
applications, all while simplifying designs and reducing BOM costs. With an internal DC-DC
converter and intelligent power control, the HST-300 provide class-leading power efficiency,
enabling ultra-low power sensitive applications. Regulatory pre-approvals reduce the
burden to enter the market.
NOTE:This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
RF warning statement:
The device has been evaluated to meet general RF exposure requirement.The
Device can be used in portable exposure condition without restricition.
The device has been evaluated to meet general RF exposure requirement.To
maintain compliance with RSS-102---Radio Frequency (RF) Exposure guidelines,
this equipment Should be installed and operated with a minimum distance of 20cm
between the radiator and your body.
1. Features
• Based on the Nordic nRF52832 SoC
• Bluetooth 5 2M LE + Advertisement
Extensions
• Complete RF solution with integrated
antenna
(
HST-300
) or U.FL connector
Integrated DC-DC converter
• No external components required
• ARM® Cortex™-M4F 32-bit processor
• Serial Wire Debug (SWD)
• Nordic SoftDevice ready
• Over-the-Air (OTA) firmware updates
• 512kB embedded flash memory
• 64kB RAM
• 32 General Purpose I/O Pins
• 12-bit/200KSPS ADC
• -40C to +85C Temperature Range
2. Applications
• App-cessories
• Beacons – iBeacon™, AltBeacon, Eddystone, etc.
• Low-Power Sensors
• Three SPI Master/Slave (8 Mbps)
• Low power comparator
• Temperature sensor
• Random Number Generator
• Two 2-wire Master/Slave (I2C compatible)
• I2S audio interface
• UART (w/ CTS/RTS and DMA)
• 20 channel CPU independent Programmable
Peripheral Interconnect (PPI)
• Quadrature Demodulator (QDEC)
• 128-bit AES HW encryption
• 5 x 32bit, 3 x 24bit Real Timer Counters
(RTC)
• NFC-A tag interface for OOB pairing
•
HST-300
Dimensions: 14.5 x 10.5 x 1.9mm