Product Specs

ManualsBrandsShenzhen Henghe Optoelectronics ManualsElectronicsLED RF controller

Product specification

Name: LED RF controller

Model: RF12#

One overview

The controller adopts advanced computer control chip, was controlled

by the 433MHz wireless signal is used to control the various LED

monochromatic lamps, light source such as light source, soft light, wall

lamp, glass curtain wall lamp and so on; with the advantages of low price,

convenient connection, easy to use and other advantages; according to

customer requirements, can be adjusted to achieve single static level ten

brightness, 8 monochromatic dynamic mode, can realize flashing,

breathing, dimmed, flicker, flicker and other modes, and there are 10

levels of speed, speed controller with large span, easy to carry, easy to

use etc.

Two technical parameters

Working temperature: -20-60

Supply voltage: DC5-24V

Output: 1 loop

The connection mode: common anode

Controller size: L35.0 * W15.0 * H4.5mm

Remote control size: L85.9 * W39.6 * H6.9mm

Packing bag size: L123.0xW90.0xH13.0mm

Net weight: 35g

GW: 40g

Static power consumption: <0.5W

Output current: <8A

Output power: 5V<30W, 12V < 144W, 24V <198W

Summary of content (5 pages)

PAGE 1
Product specification Name: LED RF controller Model: RF12# One overview The controller adopts advanced computer control chip, was controlled by the 433MHz wireless signal is used to control the various LED monochromatic lamps, light source such as light source, soft light, wall lamp, glass curtain wall lamp and so on; with the advantages of low price, convenient connection, easy to use and other advantages; according to customer requirements, can be adjusted to achieve single static level ten brightness, 8
PAGE 2
I. size of remote control: Remote control size Specifications of DC male and female head: Power input standard DC head 5.5x2.1mm 5.5x2.1mm Iii.
PAGE 3
：In any state, press to open and close the controller. ：Press this key to switch to static mode in dynamic mode. ：In the dynamic mode, press the key to switch to the static mode, every time the brightness of a level, a total of 10 ：In the dynamic mode, press the key to switch to the static mode, each according to the brightness of a level, a total of 10 ： In the boot state, press the key to switch to 100% brightness static mode. ： In the boot state, press the key to switch to 50% brightness static mode.
PAGE 4
The dynamic model: 1/2 Flash 5 flash 1 2 breath mode 6 2/3 strobe 3 gradually fade out the 4 dimmed 7 flash 1/3 8 flashing Four. Code decoding function: ： When two keys are pressed for 3-5 seconds at the same time, the one-to-one pairing function can be realized. At this time, the LED light will flash to indicate that the one-to-one pairing is successful. When the pairing is successful, only the paired remote control can be controlled remotely.
PAGE 5
FCC Caution. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.