User's Manual
EM7000 User Guide
IC Warning
22.623”
13.097”
FCC Part 15 information
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference; and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
Privacy of Communications may not be ensured when using this product.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
that is “receiving” the interference).
equipment and receiving antenna.
that to which the receiving antenna is connected.
If these measures do not eliminate the interference, please consult your dealer or an
experienced radio/television technician for additional suggestions. Also, the Federal
Communications Commission has prepared a helpful booklet, “How To Identify and
Resolve Radio/TV Interference Problems.” This booklet is available from the U.S.
Government Printing Office, Washington, D.C. 20402. Please specify stock number
004-000-00345-4 when ordering copies.
Notice: The changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
FCC RF exposure information
This product complies with FCC radiation exposure limits under the following conditions:
The base must be placed to allow a minimum of 20cm (8 inches) between the
antenna and all persons during normal operation.
The base must not be collocated or operated in conjunction with any other antenna or
transmitter.
The handset is designed for body-worn operation and meets FCC RF
exposure guidelines when used with any belt clip, carrying case, or other
accessory supplied with this product. (All necessary accessories are
included in the package; any additional or optional accessories are not
required for compliance with the guidelines.) Third party accessories
(unless approved by the manufacturer) should be avoided as these might
not comply with FCC RF exposure guidelines.
For base unit: