Operation Guide 0.9GHz Wireless Baby Monitor Kit Model No.: 821388C The graphics included are subject to minor change without notice.
1. Packing List (00.9GHz Wireless Camera X 1 @ 0.9GHz Wireless Receiver 1 @ Sensor for camera X1 (Option) @ Adapter for camera X1 Adapter for receiver X1 @AV cable X 1 *82135C means GA 8213 + GA 7613 2.
3. Structure 3-1. Structure of Camera Power Antenna Indicator Idlers Power Lens Racket Microphone Sensor sha Alarm Switch Alarm ON/OFF Battery Cover 3-2.
4. Installation 4-1. Installation of Camera 4-1-1. Basic installation of Camera 1. Locate the camera to a specific position. 2. Connect the camera to the adapter and then slide the power switch to ON position, the power indicator gets green. Note: (This camera can also use dry battery as power supply. Please load 4 AA batteries to the battery compartment at the back of camera with their polarities matched. @The AC adapter will work instead of batteries after iris plugged.
3. Rotate the rounded head of camera to a suitable angle for surveillance. 30° « 4-1-2. Camera channel setup 1. Check out the right side of the camera and there is the channel switch marked ag CH1, Ch. Each of them can be selected separately for the purpose of the multi-camera working situation or interference avoidance. 2. Press channel button of the receiver to select the same channel as the camera, The pictures will be displayed on the screen. Chl: 908MHz Ch2: 922MHz 4-1-3.
2. Connect the optional sensor jack to the camera sensor socket, put the sensor end in cotton diaper if you select the Bed-wetting Sensor detection. * Specialists recommend the sensor is not suitable for disposable pant diaper; and not suitable for touching skin directly. 1. Motlon Alarm Setup: Motion Alarm refers to the alarm against various movements, To set up motion alarm slide the alarm switch to Motion position .
4-2. Installation of Receiver 4-2-1. Basic installation of Receiver 1. Connect the receiver to the adapter and then slide the power switch to ON position. Note: (This receiver can also work on dry battery. Please load 4 AA batteries to the battery compartment at the back of receiver with. their polarities matched. @ The AC adapter will work instead of batteries after it is plugged. If the receiver is left unused for a long period of time, please unplug the adapter and remove the batteries.
3. Set the channel of receiver to be the same as camera by pressing the channel button continuously, and the pictures will display on the screen. Note: For more clear pictures, please connect the receiver to a monitor/TV ‘with AV cable (yellow for video and red for audio). a : T vase 4-2-2. Operation of Receiver 1. Volume adjustment Slide “Volume Switch” to adjust the volume of the receiver. 2. Channel selection Press “CH button” to select the appropriate channel. 8.
5. Specification Item Value “Transmission Frequency ISM 900~930 MHz. Transmission Power 10mW/CE; 2mW/FCC Operating Frequency 908MHz; 922MHz; Unobstructed Effective Range | 100m(Min.
CAUTIONS ® The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the apparatus. Turn off the Camera/Receiver if the system is not in use. The adapter is used as the disconnect device from the mains. The adapter shall remain readily operable. © The Camera/Receiver can only be completely disconnected from the ‘mains by unplug the adapter Do not cut the DC power cable of the apparatus to fit with another power source.